HP Rlve D8D82UT D8D82UT#ABA, Rlve D3K52UT 11.6 D3K52UT#ABA manual Solid-state drive

Solid-state drive

Description	Spare part number
256-GB	716749-001
128-GB	716748-001

Before removing the solid-state drive, follow these steps:

1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect the power from the computer by unplugging the power cord from the computer.

3.Disconnect all external devices from the computer.

4.Remove the battery (see Battery on page 33).

5.Remove the service cover (see Service cover on page 34).

Remove the solid-state drive:

1.Remove the Phillips PM2.0×3.0 screw (1) that secures the solid-state drive to the computer. (The solid-state drive tilts up.)

2.Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.

Reverse this procedure to install the solid-state drive.

40 Chapter 4 Removal and replacement procedures