HP StorageWorks
Mezzanine Card Installation Instructions
© Copyright 2009
First edition: January 2009
The information in this document is subject to change without notice.
The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein.Printed in Singapore.
www.hp.com
Overview
Use these instructions to install optional mezzanine cards.
Optional mezzanine cards are classified as Type I mezzanine cards and Type II mezzanine cards. The type of the mezzanine card determines where it can be installed in the server blade.
Install Type I mezzanine cards on Mezzanine 1 connector, Mezzanine 2 connector, or Mezzanine 3 connector.
Install Type II mezzanine cards on either Mezzanine 2 connector or Mezzanine 3 connector.
WARNING!
To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system components to cool before touching them.
WARNING!
Reduce the risk of electric shock by removing all AC power from the system before installing or replacing any
CAUTION:
Electrostatic discharge (ESD) can damage electronic components. Be sure that you are properly grounded (earthed) before beginning any installation procedure.
CAUTION:
Limit the number of times that a mezzanine card is installed and removed within its lifecycle to prevent connector pin damage.
Removing the access panel
1.Identify the proper server blade in the enclosure.
2.Back up all server blade data.
3.Power down the server blade.
4.Remove the server blade.
5.Lift the access panel latch and slide the access panel to the rear.
6.Remove the access panel.
Page 1