Plantronics CS545-XD manual Your Base, Base Phone Button and Switches Subscription Button

Page 20

Your Base

Base Phone Button and Switches

1

2

3

1 Subscription Button

The headset and base that came in the box are subscribed (connected) to each other. However, if you wish to use a new headset or need to restore subscription to your current headset, the units can be subscribed to each other by the following two methods.

NOTE The red CS500XD markings on the base and headset indicate an XD headset system and only XD headsets can be subscribed to XD bases. If you try to subscribe a non-XD headset to an XD base, the power LED on the base will turn off and will remain off until the non-XD headset is removed from the base.

Automatic Secure Subscription

With your system idle, docking a headset will automatically subscribe it to the base, making it the primary headset. The Power On/Subscription LED will flash white during subscription process and become solid white when the new subscription is established.

Manual Over-the-Air Subscription

1With your system idle and your headset undocked, press and hold the subscription button on the base for three seconds. The Power on/subscription light will flash white.

2Press and hold the volume up button on the headset for three seconds until the headset LED turns solid white. When the Power on/subscription LED on the base becomes solid white, the headset and base are subscribed to one another.

NOTE If the subscription process times out after two minutes or if the subscription process fails, the subscription LED on the base will go dark for three seconds and then re-illuminate steadily to indicate power is applied to the base. If this occurs, try to re-subscribe the headset again.

Ending Subscription

If the base is in subscription mode and you want to stop the base from searching for a headset, press the subscription button again. The subscription LED on the base will go dark for three seconds and then re-illuminate steadily to indicate power is applied to the base.

20

Image 20
Contents CS545-XD Contents Welcome WelcomeWhat’s in the Box Base and Headset Basics Base overviewAccessories Sold separatelyCustomize Your Headset Change Headset ConfigurationLeft Earloop Assembly Headband Assembly Position Your Headset Charge the Headset Connect the PowerConnect Your Desk Phone Connect and Configure Your Desk Phone Desk Phone standardCheck Configuration and Make a Test Call Desk Phone plus HL10 Lifter sold separately USEIf You Do Not Hear a Dial Tone Additional Parts if requiredDesk Phone plus EHS Cable Position Your Base Talk Time Your HeadsetHeadset Controls Battery Charge your second batteryReplace your headset battery Low Battery WarningOut of Range Warning Tones Adjusting Your Headset VolumeMuting Your Headset During a Call Base Phone Button and Switches Subscription Button Your BaseAutomatic Secure Subscription Manual Over-the-Air SubscriptionWideband/Narrowband Audio Switch Power On/Subscription LEDAuto Answer Switch Conference Up to Three Additional Headsets Daily UsePlace an Outgoing Call Answer an Incoming CallDesk Phone TroubleshootingHeadset Need More HELP?