5Connecting
Connecting to a computer
Connect the camera to your computer to unload images. The camera connects to your computer using a USB cable.
NOTE You can also connect your camera to a computer by using the optional HP camera dock. See Connecting to the HP camera dock later in this chapter.
NOTE If you are using a Macintosh computer, switch the camera to Disk Drive in the USB Configuration menu found in the Setup menu.
1Connect the flat end of the USB
cable to the computer.
2 Open the rubber door on the side of the camera, and connect the round end of the USB cable to the USB/TV connector on the camera.
3Turn the camera on. The HP Image Unload software will launch on your computer, and the
images in the camera will automatically unload to the computer. If there were any images on the camera that had been selected in the Share menu for printing or
4When the unload screen says “Finished”, your images have been saved and shared. You can now disconnect the camera from the computer.
41 |