HP m1280n, m1299a, m1050y (PJ720AV), m1050e (PU061AV), m1050y (PU060AV), m1050e (PJ622AV), m1297c C D

n

Location and number of connectors may vary by model.

Connecting the TV Signal Source

Connect the signal source for the TV by using the TV In coaxial connector or the S-video In connector.

Plug the connector of a coaxial cable from your TV antenna or from your TV cable (wall or set-top box) into the TV/RF-In (D) connector on the back of the PC, and then turn the connector to tighten it.

Or

Plug a cable into the S-video In (C) connector on the back of the PC; use an S-video cable (not provided) or use the S-video to composite video adapter cable and the composite video cable. Plug the other end of the cable into your set-top box or other device that is providing the signal source for the TV.

You must also plug audio cables (not provided) from your set-top box into the Audio In right (red) (A) connector and the Audio In left (white) (B) connector on the back of the PC, if you are using a set-top box with S-video or composite video output.

R	L	S-VID	TV	FM
		IN	IN	IN

A B C D

24 HP Media Center PC Getting Started Guide