HP 700 G1 manual Battery replacement, Type

Page 40

ABattery replacement

The battery installed on the computer provides power to the real-time clock. When replacing the battery, use a battery equivalent to the battery originally installed on the computer. The computer has a 3-volt lithium coin cell battery installed.

WARNING! The computer contains an internal lithium manganese dioxide battery. There is a risk of fire and burns if the battery is not handled properly. To reduce the risk of personal injury:

Do not attempt to recharge the battery.

Do not expose to temperatures higher than 60°C (140ºF).

Do not disassemble, crush, puncture, short external contacts, or dispose of in fire or water. Replace the battery only with the HP spare designated for this product.

CAUTION: Before replacing the battery, it is important to back up the computer CMOS settings. When the battery is removed or replaced, the CMOS settings will be cleared.

Static electricity can damage the electronic components of the computer or optional equipment. Before beginning these procedures, ensure that you are discharged of static electricity by briefly touching a grounded metal object.

NOTE: The lifetime of the lithium battery can be extended by plugging the computer into a live AC

wall socket. The lithium battery is only used when the computer is NOT connected to AC power.

HP encourages customers to recycle used electronic hardware, HP original print cartridges, and rechargeable batteries. For more information about recycling programs, go to http://www.hp.com/ recycle.

1.Remove/disengage any security devices that prohibit opening the computer.

2.Remove all removable media, such as compact discs or USB flash drives, from the computer.

3.Turn off the computer properly through the operating system, then turn off any external devices.

4.Disconnect the power cord from the power outlet and disconnect any external devices.

CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as the system is plugged into an active AC outlet. You must disconnect the power cord to avoid damage to the internal components of the computer.

5.Remove the computer access panel.

6.Locate the battery and battery holder on the system board.

NOTE: On some computer models, it may be necessary to remove an internal component to gain access to the battery.

7.Depending on the type of battery holder on the system board, complete the following instructions to replace the battery.

Type 1

a. Lift the battery out of its holder.

34 Appendix A Battery replacement

Image 40
Contents Hardware Reference Guide Product Notice About This Book Iv About This Book Table of contents Grounding methods Product features Standard configuration featuresFront panel components Rear panel components Serial number location Hardware upgrades Serviceability featuresRemoving the computer access panel Replacing the computer access panel Removing the front bezel Removing an optical drive bezel blank Replacing the front bezelSystem Board Connector System Board Label Color Component System board connectionsInstalling additional memory DIMMsDDR3-SDRAM DIMMs Populating Dimm socketsInstalling DIMMs Page Removing or installing an expansion card Page Page Page Drive positions Installing and removing drives Removing a slim optical drive Installing a slim optical drive Page Removing a hard drive Page Installing a hard drive Page Page Page Installing a security lock Cable lock PadlockHP Business PC Security Lock Page Page Page Battery replacement TypeType Page Preventing electrostatic damage Electrostatic dischargeGrounding methods Computer operating guidelines and routine care Optical drive precautions CleaningSafety Shipping preparationIndex
Related manuals
Manual 12 pages 58.88 Kb Manual 138 pages 33.74 Kb