HP 700 G1 manual Computer operating guidelines and routine care

Page 44

CComputer operating guidelines, routine care and shipping preparation

Computer operating guidelines and routine care

Follow these guidelines to properly set up and care for the computer and monitor:

Keep the computer away from excessive moisture, direct sunlight, and extremes of heat and cold.

Operate the computer on a sturdy, level surface. Leave a 10.2-cm (4-inch) clearance on all vented sides of the computer and above the monitor to permit the required airflow.

Never restrict the airflow into the computer by blocking any vents or air intakes. Do not place the keyboard, with the keyboard feet down, directly against the front of the desktop unit as this also restricts airflow.

Never operate the computer with the access panel or any of the expansion card slot covers removed.

Do not stack computers on top of each other or place computers so near each other that they are subject to each other’s re-circulated or preheated air.

If the computer is to be operated within a separate enclosure, intake and exhaust ventilation must be provided on the enclosure, and the same operating guidelines listed above will still apply.

Keep liquids away from the computer and keyboard.

Never cover the ventilation slots on the monitor with any type of material.

Install or enable power management functions of the operating system or other software, including sleep states.

Turn off the computer before you do either of the following:

Wipe the exterior of the computer with a soft, damp cloth as needed. Using cleaning products may discolor or damage the finish.

Occasionally clean the air vents on all vented sides of the computer. Lint, dust, and other foreign matter can block the vents and limit the airflow.

38 Appendix C Computer operating guidelines, routine care and shipping preparation

Image 44
Contents Hardware Reference Guide Product Notice About This Book Iv About This Book Table of contents Grounding methods Product features Standard configuration featuresFront panel components Rear panel components Serial number location Hardware upgrades Serviceability featuresRemoving the computer access panel Replacing the computer access panel Removing the front bezel Removing an optical drive bezel blank Replacing the front bezelSystem Board Connector System Board Label Color Component System board connectionsInstalling additional memory DIMMsDDR3-SDRAM DIMMs Populating Dimm socketsInstalling DIMMs Page Removing or installing an expansion card Page Page Page Drive positions Installing and removing drives Removing a slim optical drive Installing a slim optical drive Page Removing a hard drive Page Installing a hard drive Page Page Page Installing a security lock Cable lock PadlockHP Business PC Security Lock Page Page Page Battery replacement TypeType Page Grounding methods Electrostatic dischargePreventing electrostatic damage Computer operating guidelines and routine care Optical drive precautions CleaningSafety Shipping preparationIndex
Related manuals
Manual 12 pages 58.88 Kb Manual 138 pages 33.74 Kb