Table 2 Computer Setup—Advanced (continued)
USB Legacy Mode | Allows you to set: | |
Support | ● | Disabled |
| ||
| ● | Enabled |
|
| |
Onboard LAN | Allows you to disable/enable onboard LAN controller. | |
|
| |
Onboard LAN Boot | Allows you to disable/enable the boot ROM of the onboard LAN chip. | |
ROM |
|
|
|
| |
SATA1 Controller | Allows you to disable/enable the SATA1 Controller. | |
|
| |
SATA1 Controller | If SATA1 Controller is enabled, allows you to set the mode to: | |
Mode | ● | IDE |
| ||
| ● | AHCI |
|
| |
SATA2 Controller | Allows you to disable/enable the SATA2 Controller. | |
|
| |
Onboard Audio | Allows you to set the onboard audio to: | |
| ● | Auto |
| ● | Disabled |
| ● | Enabled |
|
| |
Internal Speaker | Allows you to set the internal speaker to: | |
| ● | Disabled |
| ● | Enabled |
|
| |
Supervisor Password | Allows you to change supervisor password. | |
|
| |
User Password | Allows you to change the user password. | |
|
|
|
Computer Setup—Power
NOTE: Support for specific Computer Setup options may vary depending on the hardware configuration.
Table 3 Computer Setup—Power
OptionDescription
After AC Power Failure Allows you to select system restart behavior after power loss:
| ● | Stay Off |
| ● | Power On |
| ● | Auto |
|
| |
XD | Disables/enables XD bit. | |
|
|
|
Computer Setup—Boot
NOTE: Support for specific Computer Setup options may vary depending on the hardware configuration.
4 Computer Setup (F10) Utility | ENWW |