Integrated Graphics Subsystem
6.3Upgrading
These systems provide direct,
The upgrade procedure is as follows:
1.Shut down the system through the operating system.
2.Unplug the power cord from the rear of the system unit.
3.Remove the chassis cover.
4.Install the graphics card into the PCIe x16 graphics slot or the PCIe x4/x16 slot.
5.Replace the chassis cover.
6.Reconnect the power cord to the system unit.
7.Power up the system unit:
✎If a PCIe graphics controller card is installed in the PCIe x16 graphics slot, the BIOS will detect the presence of the PCIe card and disable the integrated graphics controller of the processor. In this configuration, the integrated graphics controller cannot be enabled.
If a PCIe graphics controller card is installed in the PCIe x4 /x16 slot, the integrated graphics
controller of the processor will be disabled by default, but can be
✎Two PCIe graphics can be installed simultaneously to provide an alternate method for
| Technical Reference Guide | www.hp.com |