HP XP599AAABA, 2011XI manual Setting Up the Monitor, Unpacking the Monitor, Assembling the Monitor

3 Setting Up the Monitor

Unpacking the Monitor

1.Unpack the monitor. Make sure all contents are included. Store the packing box.

2.Turn off the computer and other attached devices.

3.Prepare a flat area to assemble the monitor. You may need a flat, soft, protected area for placing the monitor screen-down while preparing it for installation.

Assembling the Monitor

Place the monitor in a convenient, well-ventilated location near your computer. Connect the monitor cables after you have assembled the monitor.

CAUTION: The screen is fragile. Avoid touching or applying pressure to the LCD screen; doing so can cause damage.

TIP: For monitor displays with glossy bezels, consider the placement of the display, because the bezel might cause interfering reflections from surrounding light and bright surfaces.

1.Set the monitor panel down on a flat, soft, protected table or desk surface.

2.Slide the pedestal into the slot on the base (1) until the pedestal clicks into the base. NOTE: The bottom side of the monitor base might look different on your model.

2511x and 2711x models only: Install one screw (2) in the base to secure the pedestal to the base.

Figure 3-1Assembling the Base and Pedestal

2

6 Chapter 3 Setting Up the Monitor