HP 23.6' C5U90AA#ABA manual Agency Regulatory Notices, Product Environmental Notices

Page 20

B Agency Regulatory Notices

Federal Communications Commission Notice

European Union Regulatory Notice

Korean Notice

Japanese Notice

Power Cord Set Requirements

The monitor power supply is provided with Automatic Line Switching (ALS). This feature allows the monitor to operate on input voltages between 100–120V or 200–240V.

The power cord set (flexible cord or wall plug) received with the monitor meets the requirements for use in the country where you purchased the equipment.

If you need to obtain a power cord for a different country, you should purchase a power cord that is approved for use in that country.

The power cord must be rated for the product and for the voltage and current marked on the product's electrical ratings label. The voltage and current rating of the cord should be greater than the voltage and current rating marked on the product. In addition, the cross-sectional area of the wire must be a minimum of 0.75 mm² or 18 AWG, and the length of the cord must be between 6 feet (1.8 m) and 12 feet (3.6 m).If you have questions about the type of power cord to use, contact an authorized HP service provider.

A power cord should be routed so that it is not likely to be walked on or pinched by items placed upon it or against it. Particular attention should be paid to the plug, electrical outlet, and the point where the cord exits from the product.

Japanese Power Cord Requirements

For use in Japan, use only the power cord received with this product.

CAUTION: Do not use the power cord received with this product on any other products.

Product Environmental Notices

19

Image 20
Contents HP 24wd LED Backlit Monitor User Guide Page Check list FeaturesChapter I. Introduction Chapter II. Installation Install the pedestalConnect your monitor to your computer Disconnect the pedestal for shipping Chapter III.Monitor overview Overview of front panel controlsPower ON/OFF Switch Power indicatorMenu features Chapter IV. Operational InstructionOSD operational instructions Characters only applicable to VGA Seconds Exit Factory preset display mode Chapter V. Technical InformationProduct specifications Signal cable connector VGA InterfacePanel testing DVI InterfaceSafety and Maintenance Guidelines Important Safety InformationSafety Precautions Shipping the monitor Maintenance GuidelinesCleaning your monitor Product Environmental Notices Japanese Power Cord RequirementsAgency Regulatory Notices Energy Starr Qualification Page Page Troubleshooting Solving common problemsLocating the Rating Label Contacting SupportPreparing to Call Technical Support