HP S2331/S2331A, S2031/S2031A, S2231/S2231A manual Do the following

Page 32

Problem

Solution

 

 

Unable to hear audio from

Do the following:

built-in speakers (Select

ł Ensure the source signal is good by using headphones at the source.

models).

 

ł Press the Menu button to access the OSD menu. Select Management, and then select

 

Volume to adjust the volume.

 

ł Turn up the volume.

 

ł Ensure speaker volume is not muted or too low: Click the Windows start button™,

 

Control Panel, and Hardware and Sound. Under Audio Devices and Sound, click Adjust

 

system volume. Under Main Volume, move the slider up.

 

 

No Plug and Play.

In order for the Plug and Play feature of the monitor to work, you need a computer and graphic

 

card that are compatible with Plug and Play. Check with your computer manufacturer.

 

Check the monitor's video cable, and make sure that none of the pins are bent.

 

Make sure that the monitor drivers are installed. Monitor drivers are also available at:

 

http:// www.hp.com/support

Picture bounces, flickers, or wave pattern is present in the picture.

Move electrical devices that may cause electrical interference as far away from the monitor as possible.

Use the maximum refresh rate that your monitor is capable of at the resolution that you are using.

Monitor is always in sleep mode (amber LED).

The computer power switch should be in the On position.

The computer graphic card should be snugly seated in its slot.

Check that the monitor video cable is properly connected to the computer.

Inspect the monitor video cable, and make sure that none of the pins are bent.

Check that your computer is operational: Press the Caps Lock key and observe the Caps Lock LED found on most keyboards. The LED should either turn on or off after hitting the Caps Lock key.

Getting Support from hp.com

Before you contact customer service, refer to HP Technical Support at: http://www.hp.com/support Select your country/region, and then follow the links to the support page for your monitor.

Preparing to Call Technical Support

If you cannot solve a problem by using the troubleshooting tips in this section, you might have to call technical support. For technical support contact information, refer to the printed documentation included with the monitor.

Have the following information available when you call:

łMonitor model number (located on label on back of monitor)

łMonitor serial number (located on label on back of monitor or in the OSD display in the Information menu)

łPurchase date on invoice

30

Image 32
Contents Page Page Important Safety Instructions Features Check listChapter II. Installation Install the pedestalConnecting the Audio Cable Select Models Connect your monitor to your computerDisconnect the pedestal Chapter III. Monitor overview Overview of front panel controlsPower ON/OFF Switch Power indicatorMenu features Chapter IV. Operational InstructionOSD operational instructions Power saver Mode Display Page S2231 S2231a S2331 S2331a S2321a Factory preset display modeChapter V. Technical Information Product specifications S2031 / S2031a Models S2231 / S2231a Models S2331/ S2331a Models DVI/VGAS2321a Model Signal cable connector Panel testing PINSafety and Maintenance Guidelines Important Safety InformationSafety Precautions Shipping the Monitor Maintenance GuidelinesCleaning the Monitor Agency Regulatory Notices Federal Communications Commission NoticeModifications CablesEuropean Union Regulatory Notice Canadian NoticeAvis Canadien Japanese Notice Korean Notice Power Cord Set Requirements German Ergonomics NoticeJapanese Power Cord Requirements Product Environmental NoticesMaterials Disposal Chemical Substances11363-2006 Turkey EEE Regulation Troubleshooting Solving Common ProblemsDo the following Locating the Rating Label