York 360101-XTG-A-0108 manual Unit Cutaway

Page 4

360101-XTG-A-0108

operation. Independent blade design insures proper control and less than 1% leak rate. Includes hood and mesh bird screen filter integrated into the hood, dry bulb sensor and relief damper. Separate field accessories of single enthalpy and dual enthalpy are also available.

SINGLE ENTHALPY SENSOR - Sensor replaces dry bulb sensor standard in economizer kit. Provides improved economizer operation by sensing the dry bulb temperature from outdoors plus the enthalpy content of the outdoor air.

DUAL ENTHALPY SENSOR - Additional sensor to single enthalpy sensor. Sensor senses both the return air temperature dry bulb and humidity in conjunction with the single enthalpy to determine the most economical mix. Single Enthalpy sensor also required.

UPGRADE SAFETY PACKAGE - Contains screw-in type High pressure, Low Pressure/Loss of Charge switch, freeze protection switch and lockout relay. Switches are placed onto existing schrader ports located in the unit by furnished adapters. When abnormal conditions are sensed through the pressure switches, the unit will lock out preventing any further operation until reset or problem is corrected. Package agency approved.

HAIL GUARD KIT - Kit contains protected grilles made of expanded aluminum grilles with full perimeter inch frame. Sloped hoods are also included to assure maximum protection..

ANTI SHORT CYCLE TIMER - Automatically prevents the compressor from restarting for 5 minutes after cycled off. Not required if Thermostat 2ET07700224 and 2ET04700224 are used.

FILTER / FRAME KIT (Single Phase only) - Kit contains the necessary hardware to field install return air filters into the base unit. Pre-cut filter racks and appropriate cleanable standard size filters are shipped in one kit. (1" filter is supplied) This kit is available for single phase horizontal or vertical duct application only. Standard in all 3 Phase models.

MOTORIZED FRESH AIR DAMPER - Designed for duct mounted side return and unit mounted down shot return applications. Damper capable of providing 0% thru 50% of outdoor air (field supplied). Closes on power loss, includes hood and screen assembly.

RECTANGLE TO ROUND ADAPTERS - Kit includes one supply and one return air rectangle to round duct adapter. Adapters are preformed and designed to fit over current duct openings on the base unit. Transition is from 15” square to 14” round.

ROOF CURBS - NRCA approved curbs provide proper fit to base unit for rooftop installations. Curbs are designed to be assembled through hinge pins in each corner. Kit also provides seal strip to assure a water tight seal. Eight and 14 inch high roof curbs are available.

MANUAL OUTDOOR DAMPER - Provides 0% thru 50% outdoor air capability (field adjustable). Designed for duct mounted side return and unit mounted down shot return applications. Includes hood and screen assembly.

WALL THERMOSTAT - The units are designed to operate with 24-volt electronic and electro-mechanical thermostats. All units can operate with single stage heat / single stage cool thermostats - with or without the economizer.

LOW AMBIENT KIT - Kit provides necessary hardware to convert unit to operate in cooling cycle down to 0 °F. Standard unit operation 45 °F.

TRANSFORMER KIT - Kit provides necessary hardware to provide single phase models from factory furnished 40 VA transformer capability to 75 VA transformer capability.

ELECTRIC HEATERS - Each heater package provides easy installation of electric heat strips. Slide in design with plug in harness and agency approved. Heaters are available from 5.0 KW sizes and are designed for single point connection.

 

DIRECT DRIVE

 

CONDENSER

 

FAN MOTOR

 

HIGHLY EFFICIENT ENHANCED

BACK AND BOTTOM

COPPER TUBE/ALUMINUM FIN

EVAPORATOR COIL

RETURN AIR

HIGHLY EFFICIENT

AND SUPPLY AIR

DUCT OPENING

ENHANCED COPPER

 

TUBE/ALUMINUM FIN

 

CONDENSER COIL

 

DECORATIVE

 

PROTECTIVE

HIGH VOLTAGE

COIL GUARD

TERMINAL BLOCK

 

LOW VOLTAGE

 

TERMINAL BLOCK

 

LONG LASTING

 

POWDER PAINT

3-SPEED DIRECT DRIVE

FINISH EARTH

TONE COLOR HIGH EFFICIENCY

BLOWER MOTOR WITH

COMPRESSOR

SLIDE-OUT BLOWER ASSEMBLY

RIGIDLY

HEAVY GAUGE

MOUNTED

REMOVABLE

 

BASE RAILS

FIGURE 1 - UNIT CUTAWAY

4

Johnson Controls Unitary Products

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Standard Features / Benefits DescriptionTable of Contents Standard FEATURES/BENEFITS FIELD-INSTALLED AccessoriesUnit Cutaway Physical Data Ratings ARICooling Capacities 1-1/2 TON DEB018 Outdoor CoilCooling Capacities 2 TON DEB024 Cooling Capacities 2-1/2 TON DEB030 Cooling Capacities 3 TON DEB036 Cooling Capacities 3-1/2 TON DEB042 Cooling Capacities 4 TON DEB048 Cooling Capacities 5 TON DEB060 Side and Bottom Supply AIR Blower Performance Additional Static ResistanceElectrical Data Basic Unit Electrical Data COOLING/ELECTRIC HeatUnit Dimensions Unit Weights Center of GravityTypical Slab on Ground Installation Typical ApplicationsRoof Curb Application Typical Wiring Diagram 208/230-1-60 Power Supply DEB Models Mechanical Specifications Indoor Evaporator FAN AssemblyOutdoor Condenser FAN Assembly Unit CabinetElectric Heating Section Unit Operating CharacteristicsElectrical Requirements XTG-A-0108 XTG-A-0108 Johnson Controls Unitary Products Johnson Controls Unitary Products York Drive Norman, OK

360101-XTG-A-0108 specifications

The York 360101-XTG-A-0108 is a cutting-edge climate control system designed for residential and commercial applications, delivering optimal heating, ventilation, and air conditioning (HVAC) performance. Renowned for its efficiency and reliability, this model represents the forefront of modern HVAC technology.

One of the main features of the York 360101-XTG-A-0108 is its exceptional energy efficiency. Equipped with advanced variable-speed technology, the system adjusts its operation to match the specific heating and cooling demands of the space. This dynamic functionality allows the unit to maintain consistent temperatures while reducing energy consumption, resulting in significant cost savings on utility bills.

Another key characteristic of the York 360101-XTG-A-0108 is its quiet operation. The system is designed with sound-dampening features, which minimize noise during operation. This makes it an ideal choice for residential areas or commercial environments where noise pollution could disrupt daily activities.

The durability and longevity of the York 360101-XTG-A-0108 are further enhanced by its rugged construction and high-quality components. The unit is equipped with a robust cabinet that protects internal components from the elements, ensuring reliable performance even in harsh climates. Moreover, the advanced refrigerant technology used in this model contributes to its long service life while meeting or exceeding environmental standards.

In terms of control and monitoring, the York 360101-XTG-A-0108 boasts an intuitive user interface and smart connectivity options. It can be integrated with smart home systems, enabling users to manage their HVAC settings remotely via smartphone apps or voice-activated assistants. This connectivity not only enhances user convenience but also allows for proactive maintenance alerts, ensuring the system operates at peak efficiency.

Additionally, the unit features advanced filtration systems that enhance indoor air quality by capturing allergens, dust, and other particulates. This capability is essential for promoting a healthy living environment, particularly for individuals with allergies or respiratory conditions.

Overall, the York 360101-XTG-A-0108 stands out in the HVAC market due to its combination of energy efficiency, quiet operation, durability, smart technology integration, and superior air quality. It is designed to meet the diverse needs of modern spaces, making it a top choice for consumers seeking reliable climate control solutions.
Top Page Image Contents