York DJ 150 manual Features

036-21484-001-B-0103

Second model

nameplate inside

hinged access panel

Dual stage cooling

for maximum comfort

Compressor #2

access (high-

efficiency compressor w/crankcase heater)

Base rails w/forklift slots (three sides) and lifting holes

Roof curbs in eight and fourteen-inch heights.

Roof curbs for

transitioning from York Sunline™ footprint to the DM/DH/DJ Series footprint are available (field-installed accessory)

"Simplicity™" Control	Disconnect		Filter access
board w/screw					Filter drier
	location		(2" throw-away)
connectors for T-stat					(solid core)
	(optional disconnect switch)
wiring and Network
connection
					Condenser
					Section
					Belt-drive blower
					motor
					Slide out motor
					and blower
					assembly for easy
					adjustment and
					service
					Power ventor
					motor
					20-gauge
					aluminized steel tubular
					heat exchanger for long
					life (stainless steel option)
					Two-stage gas heating to
		Slide-out drain pan			maintain warm,
					comfortable temperature
		with brass 3/4" FPT
		connection
Tool-less door		Compressor #1 access		Intelligent control
latch		(high-efficiency		board for safe and
Side entry power		compressor w/		efficient operation
		crankcase heater)

and control wiring

knockouts

FIGURE 1 : PREDATOR™ MAGNUM COMPONENT LOCATION

FEATURES

•High Efficiency – High efficiency units are rated at 10.8 EER. Gas/electric units have electronic spark ignition and power vented combustion with steady state efficien- cies of 80%. These efficiencies meet or exceed all legis- lated minimum levels and provide low operating costs.

•Service Friendly – The Predator Magnum incorpo- rates a number of enhancements which improve service- ability.

The motor and blower slide out of the unit as a common assembly. This facilitates greater access to all the indoor airflow components, thus simplifying maintenance and adjustment.

Service time is reduced through the use of hinged, tool- less panels. Such panels provide access to frequently inspected components and areas, including the control box, compressors, filters, indoor motor & blower, and the heating section. The panels are screwed in place at the factory to prevent access by children or other unautho- rized persons. It is recommended that the panels be secured with screws once service is complete.

Service windows have been placed in both condenser section walls. Rotation of the cover allows easy access to the condenser coils for cleaning or inspection.

Unitary Products 3