HP t5135 manual Installing the stand, Removing the stand

(2)	Ethernet RJ-45 connector	(6)	Monitor connector
(3)	Parallel connector	(7)	Serial connector
(4)	Universal serial bus (USB) connectors (4)	(8)	Power connector

For more information, see the model-specific QuickSpecs at http://h18004.www1.hp.com/products/quickspecs/ QuickSpecs_Archives/QuickSpecs_Archives.html

Installing the stand

To install the stand:

1.Turn unit upside down.

2.Locate the slots on the bottom of the unit into which the tabs on the stand fit.

3.Insert the tabs into the slots (1), and then slide the stand about 1/2–inch toward the back of the unit until it locks into place (2).

Figure 1-4Installing the stand

Removing the stand

To remove the stand:

1.Turn unit upside down.

ENWW Installing the stand 3