HP Bluetooth Active Noise Cancellation Stereo Headphones manual

Page 24

Terminating a wireless connection with the enclosed Bluetooth adapter (select models only)

To terminate the connection, complete the following steps:

1.Slide the Bluetooth switch located on the left ear cup to turn off the headphones and deactivate Bluetooth.

2.If this was the first use of the headphones and Bluetooth adapter, and the pairing switch is in the on position, slide the pairing switch up to turn off pairing. In subsequent use, it is not necessary to turn on pairing to establish a wireless connection with the Bluetooth adapter.

3.Slide the power switch to turn off the Bluetooth adapter (1).

4.Unplug the Bluetooth adapter from the audio-out (headphone) jack (2) of your computer or audio device.

20 Chapter 7 Terminating the headphone wireless connection

ENWW

Antenna House XSL Formatter (Evaluation) http://www.antennahouse.com/

Page 23 Page 25
Image 24
Page 23 Page 25
Contents HP Bluetooth Active Noise CancellationStereo Headphones First Edition November Document Part Number Table of contents Enww Introduction Identifying accessory kit contents Before you begin Identifying headphone components On The headphones are charging Left-side componentsRight-side components Component DescriptionRight-side components Enww Enww Enww Using the headphones with the audio line-in cable Models only Enww Using the headphones with a Bluetooth- enabled computer Pairing using Windows Vista On the Devices tab, click Add Pairing using Windows XP Select Start Control Panel Bluetooth Devices Terminating the headphone wireless connection Terminating the headphone wireless connection Enww Index Jack
Top Page Image Contents