HP Blade Client manual System does not System unable to

Getting Started

Solving General Problems (Continued)

Problem	Cause	Solution
System does not	System unable to	Press and hold the power button
power on and the	power on.	for less than 4 seconds. If the
LEDs on the front of		hard drive LED turns green,
the computer are not		then:
flashing.		1.	Check that the voltage
			selector, located on the rear
			of the power supply on
			some models, is set to the
			appropriate voltage. Proper
			voltage setting depends on
			your region.
		2.	Remove the expansion
			cards one at a time until the

5 V_aux light on the system board turns on.

3. Replace the system board.

20 www.hp.com Getting Started