HP Advanced Communications Controllers (ACC) manual Software Removal

Software Installation and Verification

Software Removal

		Software Removal
		If a previous version of the HDLC/LAP-D protocol product is already on
		the HP-UX system, it should first be removed.
CAUTION		It is very important to follow the instructions provided with the software
		that is currently installed in the system to shutdown and remove that
		software. This procedure may change between major releases of the
		product.
	Step 1. Log in to the system as superuser.
	Step 2. Terminate the ACC Mux Subsystem by typing:
		% zmastrd kill
	Step 3. Run swremove to remove the HDLC/LAP-D protocol product.
		% swremove
NOTE		The swremove will fail if any ACC daemon is still active. Terminate any
		active ACC daemon indicated in the log file and try again.
		Any of the ACC related products can be removed by selecting them and
		then marking them for removal. (Both the terminal interface and the
		GUI interface for swremove behave the same; only the means for
		selecting items differs.)
	Step 4. Select the HDLC/LAP-D protocol product (and any other items to be
		removed) in the “Software Selection Window” and mark for removal,
		using the “Mark for Remove” function under the “Actions” menu. When
		all items are marked, select the “Remove(analysis)” action.
		Open “Logfile” to view running status of the removal process, and follow
		any screen prompts until the removal process is done.

Chapter 2 17