Accessories | HP 288048 instruction

Accessories

Gun Manifolds

Order separately; not included with gun. (See Parts, page 22.)

Part No. 241161

North America Manifold

Part No. 241162

International Manifold

Part No. 244930

High Flow Ambient or Temperature Conditioned Mani- fold for streaming or spraying.

Grounding Clamp and Wire 222011

High Pressure Ball Valves, Fluoroelastomer Seals

5000 psi (34 MPa, 345 bar) Maximum Working Pressure Can be used as fluid drain valve.

Part No. Description

210657 1/2 npt(m)

210658 3/8 npt(m)

210659 3/8 x1/4 npt(m)

Bleed-type Master Air Valve

300 psi (2.1 MPa, 21 bar) Maximum Working Pressure Relieves air trapped in the air line between the pump air inlet and this valve when closed.

Part No. Description

107141 3/4 npt(m x f) inlet and outlet

107142 1/2 npt(m x f) inlet and outlet

Brush 101892

For cleaning the gun.

In-line Fluid Filter 210500

5000 psi (35 MPa, 350 bar) Maximum Working Pressure

100 mesh. Fits onto the gun's fluid connector. 1/4-18 npsm. Includes the parts shown below.

210501

168517

Filter 164075

205264

FIG. 18: In-line Fluid Filter

Needle/Diffuser Options

Needles must be used only with the specified seat to guarantee proper seating and life.

•Standard viscosity/standard flow

•Fluid Needle 288195, 3/16 in. carbide ball

•Seat 288196

•Acid catalyzed materials/very low viscosity materials

•Fluid Needle 241468, 3/16 in. plastic ball

•Seat 288196

Gasket Filter

Gasket filter 288201, package of 10. Small filter can be installed in the inlet gasket (3) for added filtration.

Tube Fittings for Air or Water

250 psi (1.7 MPa, 17 bar) Maximum Working Pressure 160° F (71° C) temperature rating

Part No. Length

104172 1/8 npt(m) x 1/4 OD tube

597151 1/8 npt(m) x 1/4 OD tube, 90° elbow (swivel)

Temperature Sensor and Cable

For temperature conditioned manifold

Part No. Length

198457 RTD Sensor, 100 ohm, 1/8 npt(m) with 3 pin Picofast connector

198458 RTD cable, 6 ft. (1.83 m) Flex cable to St. Clair connector

311053C