HP 2100 manual Load paper

hp psc 2100 series

2Tap the stack on a flat surface to align the edges of the paper, and then check the paper for the following:

–Make sure it is free of rips, dust, wrinkles, and curled or bent edges.

–Make sure all the paper in the stack is the same size and type, unless you are working with photo paper.

3Insert paper into the paper tray print-side down until it stops. If you are using letterhead, insert the top of the page first.

Be careful not to use too much or too little paper. Check that the stack of paper contains several sheets but is no higher than the top of the paper-length guide.

4Slide the paper-width and paper-length guides in until they stop at the edges of the paper. Make sure that the paper stack lies flat in the paper tray and fits under the tab of the paper-length guide.

5Replace the output tray.

load paper 9