10Connectivity
•Add the HP Photosmart to a network
•Change from a USB connection to a wireless network
•Connect a new printer
•Change network settings
•Tips for setting up and using a networked printer
•Advanced printer management tools (for networked printers)
Add the HP Photosmart to a network
•WiFi Protected Setup (WPS)
•Wireless with a router (infrastructure network)
WiFi Protected Setup (WPS)
These instructions are for customers who have already setup and installed the printer software. For first time installation refer to the setup instructions that came with the printer.
To connect the HP Photosmart to a wireless network using
A wireless 802.11b/g/n network that includes a
A desktop computer or laptop with either wireless networking support, or a network interface card (NIC). The computer must be connected to the wireless network that you intend to install the HP Photosmart on.
NOTE: If you have a
Push Button (PBC) method
1.Press the
2.Press and hold the Wireless button on the printer until the wireless light starts blinking. Press and hold for 3 seconds to start WPS push button mode .
NOTE: The product begins a timer for approximately two minutes while a wireless connection is established.
Wireless Settings Menu method
1.Touch the Wireless button on the printer display to see the Wireless menu. If the printer is printing, in an error state, or performing a critical task, wait until the task has been completed or the error cleared before pressing the Wireless button.
2.Select Wireless Settings from the printer display.
3.Select
4.If you have a
NOTE: The product begins a timer for approximately two minutes during which the corresponding button on the networking device needs to be pressed or the router PIN needs to be entered on the router’s configuration page.
Connectivity 41