HP 6110v manual Attach the ADF tray extension, Attach the cover Remove output tray and load paper

1 START HERE 2 Install the software first

			12
a	Turn your PC on and wait for the Windows	9	3
	desktop to appear.
b	Close any open programs, including virus-		6
	checking programs.

Windows desktop

aInsert the HP OfficeJet software CD.

bFollow the onscreen instructions.

c	When prompted to set up your
	device, go to step 3.

Notes:

If nothing appears on your computer screen after inserting the CD, go to the Windows task bar, click Start, and then choose Run. In the Run dialog box type d:\setup.exe (d= your PC's CD ROM drive letter).

You may see the minimum requirements screen first.

Make sure you are using the correct side of the poster.

Windows users: Follow the steps in order. Do not connect the USB cable until instructed to do so.

See your box for exact contents and system requirements.

3Attach the ADF tray extension

Slide the automatic document feeder (ADF) tray extension into the top of the unit. Match the gray tabs with the black slots.

4Attach the cover

a

5 Remove output tray and load paper

b

a	Insert the two tabs of the cover into
	the top slots on the unit.
b	Tilt the cover down and press firmly.
	Make sure the tabs lock into place
	and the cover is even with the unit.	b

a

c

one

5 Step 5 continued 6 Connect the phone cord

Use blank white paper to prepare for print alignment.

1 To wall jack

2 To phone

7	Connect the power cord and the USB cable		8	Turn on your HP OfficeJet
		3
a		b
	1	Make sure you have
		completed step 1
		before this step.

poster series all-in-

f

9Insert and align the print cartridges

c Black label (56)

2

10 Finish software setup

Windows setup hp officejet 6100

Make sure to remove any packing material from inside the unit.

a

b

latches

a	Lift the print carriage door up	b	Remove the bright pink tape
	until it catches. Wait for the
	print carriage to move to the		from the print cartridges. Do not
	center. Lift the blue and gray		touch the gold-colored contacts
	latches.		or re-tape the cartridges.

e

d Color label (57)

cHold the black print cartridge with the label on top. Slide the cartridge into the right(gray

	latch) side of the print carriage.	e	Pull the end of the gray latch toward
			you, press down until it stops, and
d	Hold the tri-color print cartridge with the label		then release. Make sure the latch
			catches below the bottom tabs. Repeat
	on top. Slide the cartridge into the left(blue		with the blue latch.
	latch) side of the print carriage.

f

fMake sure both latches are locked into position. Close the print carriage door.

g

gPress Enter to begin alignment. After a page prints, alignment is complete. Discard or recycle this page.

Look for the screen with the green checkmark, and then continue. If you see the screen with the red checkmark, follow the instructions in the Readme.

11 Set up faxing and take Product Tour

12

93

6

Make sure your PC is on.

Follow the onscreen instructions to enter your name, phone number, and other important settings. See the reference guide for more details.

Take the Product Tour to learn about your new HP OfficeJet.

www.hp.com/support

Copyright Hewlett-Packard Company 2002 Printed in USA