United States Stove 3600PB, 3800PB owner manual Chimney Height

Page 8

This prevents any amount of condensed or liquid creosote from running down the outside of the pipe or the stove top. All joints, including the flue collar connection must be secured with three sheet metal screws to ensure that the sections do not separate.

For the best performance the chimney connector should be as short and direct as possible, with no more than two 90° elbows. The maximum horizontal run is 36” and a recommended total length of stovepipe should not exceed 10 feet. Always slope horizontal runs upward ¼” per foot toward the chimney.

No part of the chimney connector may pass through an attic or roof space, closet or other con- cealed space, or through a floor ceiling. All sections of the chimney connectors must be accessible for cleaning. Where passage through a wall or partition of combustible construction is desired, the installation must conform with NFPA 211 or CAN/CSA-B365, and is also addressed in this manual.

Chimney

DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER APPLIANCE. DO NOT CONNECT TO ANY AIR DISTRIBUTION DUCT OR SYSTEM.

This room heater must be connected to a 6” factory built UL 103 HT chimney (ULC S629, in Cana- da) or a code-approved masonry chimney with a flue liner.

Chimney Height

A masonry chimney or a listed factory-build chimney must be the required height above the roof and any other nearby obstructions. The chimney must be at least 3’ (90 cm) higher than the highest point where it passes through the roof and at least 2’ (60 cm) higher than the highest part of the roof or structure that is within 10’ (305 cm) of the chimney, measured horizontally.

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Cast Iron Room Heater Table of Contents Stove Safety Adequate Provision of Air Before installing your stoveSpecifications Installation Floor ProtectionInstallation Clearances 3600PB 3800PBDo not use the connector pipe as a chimney Chimney ConnectionChimney Chimney HeightFactory Built Chimney Masonry Chimney Combustible Wall Chimney Connector Pass-Throughs Operating Your Stove FuelFirst operation of stove Air controlsOvernight Burning RefuelingAsh Removal Stove Maintenance Care of GlassTrouble Shooting Smoke in Room Fire Burns too QuicklyWarranty Policy & Procedures Stove Limited Warranty3600PB Parts Diagram & List 12 13 14Hob HF717U-1 Ussc

3800PB, 3600PB specifications

The United States Stove Company has made a name for itself in the realm of home heating solutions, known particularly for its reliable wood and pellet stoves. Among its impressive lineup, the 3600PB and 3800PB models stand out for their efficiency, functionality, and innovative features.

The United States Stove 3600PB is designed for homeowners seeking an efficient heating source. This model boasts a heat output rating of up to 64,000 BTUs, which makes it capable of warming spaces up to 2,500 square feet. Its substantial hopper capacity allows for extended burn times, ensuring that users can enjoy consistent warmth without the need for frequent refueling. The 3600PB employs a direct venting system, which enhances efficiency by ensuring that outside air is used for combustion, significantly reducing indoor air pollution.

On the other hand, the 3800PB model pushes performance even further with a heat output of up to 80,000 BTUs. This makes it ideal for larger spaces or homes with open floor plans. The 3800PB also incorporates a large capacity hopper, capable of holding up to 120 pounds of pellets, allowing for longer burn times that can easily extend through the night. Both models come equipped with a digital control panel that simplifies operation and allows users to adjust heat settings and monitor pellet levels easily.

In terms of construction, both the 3600PB and 3800PB housings are built with robust materials designed to withstand the rigors of regular use. The heavy-duty steel design not only enhances durability but also improves heat retention, allowing for superior heating efficiency. These models also feature an automatic ignition system, which makes starting the stove effortless and reduces the need for manual intervention.

Safety is paramount in stove design, and both the 3600PB and 3800PB come with built-in safety features such as low-oxygen sensors and thermal overload protection. Additionally, the advanced airflow systems in these models are engineered to provide a consistent burn while minimizing emissions, aligning with modern environmental standards.

In conclusion, the United States Stove 3600PB and 3800PB are excellent choices for anyone looking to invest in reliable and efficient heating solutions. With their robust construction, advanced technology, and user-friendly features, they promise to deliver both comfort and convenience in a variety of residential settings. Whether you’re heating a compact space or a sprawling home, these models are designed to meet diverse heating needs while embracing efficiency and safety.
Top Page Image Contents