HP C8100 manual Create a network profile for other operating systems

Chapter 2

1.In the Control Panel, double-clickNetwork Connections.

2.On the Network Connections window, right-click the Wireless Network Connection. If you see Enable on the pop-up menu, select it. Otherwise, if you see Disable on the menu, the wireless connection is already enabled.

3.Right-click the Wireless Network Connection icon, and then click Properties.

4.Click the Wireless Networks tab.

5.Select the Use Windows to configure my wireless network settings check box.

6.Click Add, and then do the following:

a. In Network name (SSID) box, type in a unique network name of your choice.

NOTE: The network name is case sensitive, so it is important to remember any uppercase (capital) and lowercase (small) letters.

Network setup

b. If there is a Network Authentication list, select Open. Otherwise, go to the next step.

c. In the Data encryption list, select WEP.

NOTE: It is possible to create a network that does not use a WEP key. However, HP recommends using a WEP key in order to secure your network.

d. Make sure that the check box is not selected next to The key is provided for me automatically. If it is selected, click the check box to clear it.

e. In the Network key box, type a WEP key that has exactly 5 or exactly 13 alphanumeric (ASCII) characters. For example, if you enter 5 characters, you might enter ABCDE or 12345. Or, if you enter 13 characters, you might enter ABCDEF1234567. (12345 and ABCDE are examples only. Select a combination of your choosing.)

Alternatively, you can use HEX (hexadecimal) characters for the WEP key. A HEX WEP key must be 10 characters for 40 bit encryption, or 26 characters for 128 bit encryption.

f. In the Confirm network key box, type the same WEP key you typed in the previous step.

g. Write down the WEP key exactly as you typed it, including uppercase and lowercase letters.

NOTE: You must remember the exact uppercase (capital) and lowercase (small) letters. If you enter your WEP key incorrectly on the HP All-in-One, the wireless connection will fail.

h. Select the check box for This is a computer-to-computer (ad hoc) network; wireless access points are not used.

i. Click OK to close the Wireless network properties window, and then click OK again.

j. Click OK again to close the Wireless Network Properties Connection window.

Create a network profile for other operating systems

If you have an operating system other than Windows XP, HP recommends that you use the configuration program that came with your wireless LAN card. To find the configuration program for your wireless LAN card, access your computer's list of programs.

12 Network setup