United States Stove 1537M guide

RULES FOR SAFE INSTALLATION AND OPERATION

Read these rules and the instructions carefully. Failure to follow them will cause a hazard that could result in death, serious bodily injury, and/or property damage.

1.Check your local codes. The installation must comply with their rulings.

2.Do not install this furnace in a mobile home or trailer.

3.Always connect this furnace to a chimney and vent to the outside. Never vent to another room or inside a building.

4.Do not connect this furnace to an aluminum Type B gas vent. This is not safe and is prohibited by the National Fire Protection Association Code. This furnace requires a masonry or UL Listed Factory Built Chimney for residential Type 103 HT or Building Heating Appliance Chimney. Use a 6" diameter chimney or larger, that is high enough to give a good draft. (See page 7)

5.Be sure that if a masonry chimney is used, it is safely constructed, lined and in good repair. Have the chimney inspected by the Fire Department or an inspector.

6.Inspect chimney connector and chimney before and frequently during the heating season for any deposit of creosote or soot which must be removed (See Chimney Maintenance, page 15).

7.Provide air for combustion into the room where the furnace is located. If the intake is not in the same room, air must have free access to the room.

8.CAST IRON PARTS MUST BE "SEASONED" TO AVOID CRACKING, BUILD ONLY SMALL FIRES ON FIRST USE.

9.To prevent injury, do not allow anyone to use this furnace who is unfamiliar with the correct operation of the furnace.

10.For further information on using your furnace safely, obtain a copy of the National Fire Protection Association (NFPA) publication "Chimney's, Fireplaces and Solid Fuel Burning Appliances" NFPA 211. The address of the NFPA is Batterymarch Park, Quincy, MA 02269.

11.Keep the ashpit section free of excess ashes. Do not allow ashes to stack higher than the sides of the ash pan.

12.DISPOSAL OF ASHES- Place ashes in a metal container with a tight fitting lid. Keep the closed container on a noncombustible floor or on the ground, well away from all combustible materials. Keep the ashes in the closed container until all cinders have thoroughly cooled. The ashes may be buried in the ground or picked up by a refuse collector.

13.CAUTION- The special paints used on your furnace may give off some smoke while they are curing during first few fires., Build small fires at first. The metal used in construction of the furnace and duct work has a light coating of oil. This could give off smoke and/or odor from registers when furnace is used for the first time. This should disappear after a short period of time. Once this burn-off has occurred, it should not reoccur.

14.CARING FOR PAINTED PARTS- This furnace has a painted outside jacket, which is durable, but it will not stand rough handling or abuse. When installing your furnace, use care in handling. Clean with soap and warm water when furnace in not hot. DO NOT use any acids or scouring soap, as these wear and dull the finish. DISCOLORATION WILL OCCUR IF THE FURNACE IS OVERHEATED. FOLLOW OPERATING INSTRUCTIONS CAREFULLY.

15.Keep the feed and ash doors closed at all times except while tending the furnace.

Your Furnace is designed to be installed in a parallel air flow arrangement with a gas or oil-fired forced air upflow-type central furnace, or it may be installed as a central furnace.

1537M specifications

The United States Stove 1537M is a remarkable wood-burning stove that combines efficiency, aesthetic appeal, and modern features. Designed for residential heating, this model is particularly suited for medium-sized spaces, making it a popular choice among homeowners seeking an economical and environmentally friendly heating solution.

One of the primary features of the United States Stove 1537M is its impressive heating capacity. It can effectively heat areas up to 1,500 square feet, ensuring warmth during the cold winter months. The stove utilizes a large firebox that can accommodate logs up to 18 inches long, allowing for longer burn times and reduced need for frequent reloading.

The 1537M incorporates advanced technologies to maximize combustion efficiency and minimize emissions. It is equipped with a secondary combustion system that ensures that any unburned gases are ignited in the upper part of the firebox. This not only increases the heat output but also reduces the amount of creosote buildup in the chimney, enhancing safety and maintenance ease.

The stove features a built-in thermostat control, enabling users to regulate the interior temperature easily. Additionally, it boasts an air wash system designed to keep the glass door clear, offering a beautiful view of the flames while enhancing visibility and ambiance in any room.

Constructed with robust materials, the United States Stove 1537M is built to last. Its durable steel body ensures long-term usage, while the cast iron door provides a traditional look with the added benefit of durability and heat retention. The attractive design features a classic black finish, blending seamlessly with various home interiors.

Moreover, this model prioritizes user comfort and convenience. It includes a large loading door for easy access to the firebox, allowing for stress-free loading of wood. Cleaning is also straightforward, with a removable ash pan that simplifies the disposal of ashes.

In summary, the United States Stove 1537M stands out as a top-quality wood-burning stove that effectively combines functionality, efficiency, and aesthetic appeal. With its advanced combustion technologies, substantial heating capacity, and ease of use, this stove is an excellent investment for those looking to enhance their home heating solutions while maintaining a cozy and inviting atmosphere.