HP Thunderbolt-2 Ie 1-port I/O Card manual HP Z230 models

Page 11

●HP Z230 models:

Plug the cable into the system board connector labeled E102 as follows:

(1)Small form factor models (near edge of board)

(2)Tower models (between slots 3 and 4)

NOTE: System board appearance may vary.

Step 2—Installing the Thunderbolt add-in card

Image 11

Contents 753804-001 Page Table of contents Page Introduction Kit contentsPage Download Index click Bios Preparing for component installationInstalling the Thunderbolt add-in card Page HP Zx40 models HP Zx20 models HP Z230 models Page Select Driver Controller Reassembling the computerLoading the Thunderbolt add-in card driver Select Drivers & DownloadsThunderbolt 2 PCIe Card Installation