![](/images/new-backgrounds/1224154/22415451x1.webp)
Troubleshooting
4-1 How to use DCU
4-1-1 DCU Setup
You can examine the malfunction of the printer. To perform DCU, open the front discharge cover and leave the connect the harness wire(10 pin/4 pin) to the CN10(4 pin) of the Main control board.
4-1-2 Code
Connect DCU to the printer and turn the power on. It show 7 LED on the panel and each code tells the function of the printer.
Normal Code
While printing or warming up, it indicate the position of the paper
61 | Warm up | The printer is on, the cover is open or close. |
Ready(kind of paper) | The printer is ready, the paper is detected when the first paper is printed. | |
|
| 00: Legal ,01: Letter ,02: A4 ,03: EXEC ,04: B5 ,05: Folio, 06: A5/A6 |
20, 21, 22 | Print Start | The engine controller received the print order from the video controller. |
|
| 20: 1st, 21: MP, 22: SCF |
30 | Feed Sensor On | The paper is passing out of the Feed Sensor. |
40 | Feed Sensor off | The paper has passed out of the Feed Sensor. |
50 | Paper Out | The paper has passed out of Exit Sensor. |
69 | Sleep Mode | The fuser power turned off to minimize the power consumption. |
|
|
|
Error Code
When detecting the malfunction, the printing is stopped to indicate error code.
60, 62, 68 | Fuser Error | The error in the fuser occurred. There is a short circuit in the thermistor and the |
|
| thermostat while printing, Low Temperature Error occurs. |
|
|
|
|
| • 60: Open Fuser Error |
|
| • 62: Low Heat Error |
|
| • 68: Over Heat Error |
64 | Cover Open | The Printer Cover is open. |
65 | CRU Error | The Toner Cartridge not installed, |
70 | No Paper | No paper in the paper cassette. |
71 | Paper Jam 0 | The front part of paper is jammed between pickup unit and Feed sensor. |
72 | Paper Jam 1 | The front part of paper is jammed between the Discharge sensor and Feed sensor. |
73 | Paper Jam 2 | The front part of paper is jammed just after passing through the discharge sensor. |
76 | Out Bin Full | The Out bin is filled with paper. |
95 | LSU Not Ready | LSU Scanner Motor not ready or Hsync signal not output. |
|
|
|
Samsung Electronics |