HP Z27i 27-inch manual Rear Components, Z24i Model

Page 10

Rear Components

Z24i Model

Component		Function

1	USB 2.0 Downstream	Connects optional USB devices to the monitor.
	Connectors (side panel)

2	Master Power Switch	Turns off all power to the monitor.
		NOTE: Putting the switch in the Off position will yield the
		lowest power state for the monitor when not in use.

3	AC Power Connector	Connects the AC power cord to the monitor.

4	DisplayPort	Connects the DisplayPort cable to the monitor.

5	DVI-D	Connects the DVI-D cable to the monitor.

6	VGA	Connects the VGA cable to the monitor.

7	USB 2.0 Upstream	Connects the USB hub cable to the monitor's USB hub
	Connector	connector and to a host USB port/hub.

8	USB 2.0 Downstream	Connects optional USB devices to the monitor.
	Connectors

4	Chapter 2 Setting Up and Using the Monitor

Image 10

Contents HP Z24i, Z27i, and Z30i IPS Displays First Edition August Document Part Number About This Guide Iv About This Guide Table of contents Z27i Model Z30i Model Product Features HP IPS MonitorsPage Setting Up and Using the Monitor Installing the StandRear Components Z24i ModelZ27i and Z30i Models HdmiConnecting the Cables Page Page Page Front Panel Controls Control FunctionAdjusting the Monitor Page Adjusting the Monitor Turning on the Monitor HP Watermark and Image Retention PolicyConnecting USB Devices Removing the Monitor StandMounting the Monitor Page Page Page Page Locating the Serial Number and Product Number Locating the Information CardPower Saving Features Installing a Cable LockPower-Saver Mode Auto-Sleep Mode Sleep TimerPage Reference Guides Product SupportZ24i Model Z27i ModelZ27i Model Z30i Model Recognizing Preset Display Resolutions Preset Pixel Format Horz Freq kHz Vert Freq HzZ27i Model Z30i Model Entering User Modes