HP x2301 Diagonal Micro Thin High-Bandwidth Digital Content Protection Hdcp, Adjusting the Tilt

Page 15

High-Bandwidth Digital Content Protection (HDCP)

Your monitor supports HDCP and can receive high-definition content. High-definition content is available in many sources, such as Blu-ray Disc devices or HDTV air or cable broadcasts. If you do not have an HDCP-enabled monitor, a blank screen or a lower resolution picture appears when playing high-definition protected content. Your computer graphics card and monitor must both support HDCP to display protected content.

Turning on the Monitor

1.Press the power button on the computer.

2.Press the power button on the monitor.

CAUTION: Burn-in image damage might occur on monitors that display the same static image on screen for a prolonged period of time (at least 12 consecutive hours of non-use). To avoid burn-in image damage on the monitor screen, activate a screen saver application or turn off the monitor when it is not in use for a prolonged period of time. Image retention is a condition that might occur on all LCD screens. Monitors with a burned-in image are not covered under HP warranty.

When the monitor is powered on, a Monitor Status message appears for 5 seconds. The message shows which input is the current active signal, the status of the auto-switch source setting (On or Off), the default source signal, the current preset display resolution, and the recommended preset display resolution.

Selecting Video Input Connectors

The input connectors are:

●VGA (analog)

●DVI-D connector (digital)

●HDMI connector (digital)

The monitor automatically scans the signal inputs for an active input and uses that input for the display. If two inputs are active, the monitor will display the default input source. If the default source is not an active input, then the monitor displays the other input if it is active. You can change the default source in the OSD by pressing the Menu button and selecting Source Control > Default Source.

Adjusting the Tilt

For optimal viewing, adjust the screen tilt to your own preference, as follows:

1.Face the front of the monitor and hold the base so that you do not topple the monitor while changing the tilt.

ENWW

High-Bandwidth Digital Content Protection (HDCP)

9

Page 14 Page 16
Image 15
Page 14 Page 16
Contents HP x2301 LCD Monitor First Edition June Document Part Number About This Guide About This Guide Table of contents Appendix B Technical Specifications HP x2301 LCD Monitor Product FeaturesEnww Safety and Maintenance Guidelines Important Safety InformationSafety Precautions Maintenance Guidelines Cleaning the MonitorShipping the Monitor Maintenance Guidelines Unpacking the Monitor Setting Up the MonitorConnecting Monitor Cables Connecting the DVI-D CableConnecting the Hdmi Cable select models Connecting the VGA CableFor additional information, see Technical Specifications on Connecting the Power CordTurning on the Monitor High-Bandwidth Digital Content Protection HdcpSelecting Video Input Connectors Adjusting the Tilt5Tilt Adjustment Setting Up the Monitor Installing Drivers Operating the MonitorCD Software and Utilities Control buttons are located on the base of the monitor Control ButtonsOSD Menu Selections Using the On-Screen Display OSDEnww Power-Saver Feature on To place the monitor in sleep mode Support Identifying Monitor ConditionsPower-Saver Feature Resolving Common Issues TroubleshootingLocating the Rating Label IssueSolutionHP x2301 Model Technical SpecificationsEntering User Modes Preset Video ModesLCD Monitor Quality and Pixel Policy Cables Agency Regulatory NoticesFederal Communications Commission Notice ModificationsJapanese Notice Korean Notice Power Cord Set Requirements Canadian NoticeAvis Canadien Japanese Power Cord Requirements Product Environmental NoticesEnergy Star Qualification Product Environmental Notices Turkey EEE Regulation
Top Page Image Contents