HP x2301 Diagonal Micro Thin manual Identifying Monitor Conditions, Support

Icon	Main Menu Options	Sub-menu Options	Description
		FW Version	Reports the firmware version of the
			monitor.
		Backlight Hours	Reports the total hours of backlight
			operation.
		Service Support	For service support, see the HP Technical
			Support website at http://www.hp.com/
			support.
	Factory Reset		Returns settings to factory defaults.
	Source Control		Selects the video input signal. The factory
			default by priority is DVI, HDMI, and
			then VGA.
		DVI	Selects DVI as the video input signal.
		HDMI	Selects HDMI as the video input signal.
		VGA	Selects VGA as the video input signal.
		Default Source	Selects the default or primary video input
			signal when the monitor is connected to
			two active and valid video sources. The
			monitor automatically determines the
			video format.
		Auto Switch Source	Turns the system's automatic video signal
			input to On or Off. The factory default is
			On.
	Exit		Exits the OSD menu screen.

Identifying Monitor Conditions

Special messages appear on the monitor screen for the following monitor conditions:

●Monitor Status—When the monitor is powered on or when the input source signal is changed, a Monitor Status message appears for 5 seconds. The message shows which input is the current active signal, the status of the auto-switch source setting (On or Off), the default source signal, the current preset display resolution, and the recommended preset display resolution.

●Input Signal Out of Range—Indicates the monitor does not support the video card's input signal because its resolution or refresh rate are set higher than the monitor supports. Change your video card settings to a lower resolution or refresh rate. Restart your computer for the new settings to take effect.

●Power Button Lockout—Indicates the power button is locked. If the power button is locked, the warning message Power Button Lockout appears. If the power button is locked, press and hold the power button for 10 seconds to unlock the power button function. If the power button is unlocked, press and hold the power button for 10 seconds to lock out the power button function.

●Monitor Going to Sleep—Indicates the screen display is entering a sleep mode.

ENWW Identifying Monitor Conditions 17