ASRock 960GC-GS FX manual Dram Voltage, Memory Timing, Power Down Enable, Bank Interleaving

You can set one of the standard values as listed for DDR3 memory mod- ules: [400MHz DDR3_800], [533MHz DDR3_1066], [667MHz DDR3_1333] and [800MHz DDR3_1600].

DRAM Voltage

Use this to select DRAM voltage. The default value is [Auto].

Memory Timing

	BIOS SETUP UTILITY
OC Tweaker
Memory Timing
Power Down Enable	[Enabled]
Bank Interleaving	[Auto]
Channel Interleaving	[Auto]
CAS Latency (CL)	[Auto]
TRCD	[Auto]
TRP	[Auto]
TRAS	[Auto]
Command Rate	[Auto]
TRC	[Auto]		Select Screen
			Select Item
TWR	[Auto]
		+-	Change Option
TRFC	[Auto]
		F1	General Help
TRRD	[Auto]
		F9	Load Defaults
TWTR	[Auto]
TRTP	[Auto]	F10	Save and Exit
		ESC	Exit
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.

Power Down Enable

Use this item to enable or disable DDR power down mode.

Bank Interleaving

Interleaving allows memory accesses to be spread out over banks on the same node, or accross nodes, decreasing access contention.

Channel Interleaving

It allows you to enable Channel Memory Interleaving. The default value for DDR2 is [Hash 1]. The default value for DDR3 is [Hash 2].

CAS Latency (CL)

Use this item to adjust the means of memory accessing. The default value is [Auto].

TRCD

Use this to adjust TRCD values. The default value is [Auto].

TRP

Use this to adjust TRP values. The default value is [Auto].

TRAS

Use this to adjust TRAS values. The default value is [Auto].

Command Rate

Use this item to change Command Rate Auto/Manual setting. Min: 1N.

Max: 2N. The default is [Auto].

36