RX1200 Block Diagram

	This symbol is intended to		This symbol is intend-

		CAUTION
	alert the user to the pres-		ed to alert the user to
	ence of uninsulated “dan-		the presence of impor-
		RISK OF ELECTRIC SHOCK
	gerous voltage” within the		tant operating and
product’s enclosure that may be of suf-		DO NOT OPEN	maintenance (servicing) instructions
ficient magnitude to constitute a risk of			in the literature accompanying the
electric shock to persons.			appliance.

IMPORTANT! FOR YOUR PROTECTION, PLEASE READ THE FOLLOWING:

WATER AND MOISTURE: Appliance should not be used near water (near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc). Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings.

POWER SOURCES: The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance.

GROUNDING OR POLARIZATION: Precautions should be taken so that the grounding or polar- ization means of an appliance is not defeated.

POWER CORD PROTECTION: Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance.

SERVICING: The user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel.

FUSING: If your unit is equipped with a fuse receptacle, replace only with the same type fuse. Refer to replacement text on the unit for correct fuse type.

SAFETY INSTRUCTIONS (EUROPEAN)

The conductors in the AC power cord are colored in accordance with the following code.

GREEN & YELLOW—Earth

BLUE—Neutral

BROWN—Live

U.K. MAIN PLUG WARNING: A molded main plug that has been cut off from the cord is unsafe. NEVER UNDER ANY CIRCUMSTANCES SHOULD YOU INSERT A DAM-

AGED OR CUT MAIN PLUG INTO A POWER SOCKET.

LIMITED WARRANTY

Your Carvin product is guaranteed against failure for 1 YEAR unless otherwise stated. Carvin will service and supply all parts at no charge to the customer providing the unit is under warranty. Shipping costs are the responsibility of the customer. CARVIN DOES NOT PAY FOR PARTS OR SERVICING OTHER THAN OUR OWN. A COPY OF THE ORIGINAL INVOICE IS REQUIRED TO VERIFY YOUR WARRANTY. Carvin assumes no responsibility for horn drivers or speakers damaged by this unit. This warranty does not cover, and no liability is assumed, for damage due to: natural disasters, accidents, abuse, loss of parts, lack of reasonable care, incorrect use, or failure to follow instructions. This warranty is in lieu of all other warranties, expressed or implied. No representative or person is authorized to represent or assume for Carvin any liability in connection with the sale or servicing of Carvin products. CARVIN SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES.

When RETURNING merchandise to the factory, you may call for a return authorization number. Describe in writing each problem. If your unit is out of warranty, you will be charged the current FLAT RATE for parts and labor to bring your unit up to factory spec- ifications.

MAINTAINING YOUR EQUIPMENT

Avoid spilling liquids or allowing any other foreign matter inside the unit. The panel of your unit can be wiped from time to time with a dry or slightly damp cloth in order to remove dust and bring back the new look. As with all pro gear, avoid prolonged use in caustic environments (salt air). When used in such an environment, be sure the mixer is adequately protected by a cover.

CAUTION

RISK OF ELECTRIC SHOCK

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL! THIS UNIT CONTAINS HIGH VOLTAGE INSIDE!

LEFT

RIGHT MON1 MON2

(x2)EFF

CHANNEL 12 (or 8)

BYPASSES

SEVEN BAND

LEFT

BREAK SWITCH

XLR OUT

GRAPHIC

MIC

PAN

EQUALIZER

THREE BAND

LEFT (AMP1)

TO AMP 1

MIC

CHANNEL TONE

INSERT

PRE

CONTROLS

PAD

SEVEN BAND

RIGHT

LINE IN PAD

GRAPHIC

XLR OUT

(-20dB bal.)

GAIN

EQUALIZER

(-26dB unbal.)

RIGHT (AMP2)

CHANNEL

TO AMP 2

MID LOW

MAIN L-R

LEVEL

INSERT

EFF SND

LINE

LINE - INS

(x2)

(INSERT)

SWITCH

MON 1

MONO (SUB)

CHANNEL

TAPE OUT

1/4" OUT

BREAK

SUB X-OVER

MON 2

SWITCH

120Hz

TAPE OUT

TAPE INPUT

LEVEL

SEVEN BAND

MONITOR

GRAPHIC

1/4" OUT

EQUALIZER

MONITOR1 (AMP3)

TO AMP 3

TAPE IN

INSERT

SEVEN BAND

LEVEL

MONITOR 1

GRAPHIC

EQUALIZER

MONITOR

LEVEL

MONITOR2 (AMP4)

1/4" OUT

STEREO DSP

MAIN DSP

TO AMP 4

LEVEL (x2)

INSERT

RETURNS

(x2)

MONITOR 2

LEVEL

GAIN

REAR INSERTS AND AMPS 1-4

REDUCTION

FOR DSP

FROM

INSERT

DSP TO

DSP SEND

(x2)

FRONT

CLIP

POWER

PROTECTION

SPEAKER

MONITORS 1-2

PANEL

LIMITER

AMP

RELAY

OUTPUTS

(x2)

EXTERNAL

SEND

(x2)