Diagram 7
C clamp
3.Insert the long screws through the mounting holes on the clamp. See Diagram 7. You may need to squeeze the ends of the clamp together to install the screws. Tighten the screws using a Phillips head screwdriver until the clamp remains securely in place. A gap should remain between the opposite sides of the clamp. See Diagram 7.
Note: If you have difficulty holding the clamp together, you may want to use a C clamp (see insert on Diagram 7) to help compress the clamp ends while you tighten the screws.
4.Unlock and remove the mounting bracket from the back of the electronic console. (Unlock the mounting bracket by pushing it down toward the base of the console.) Refer to Diagram 2 on page 6.
5.Positionthemountingbracketontothehandrailclampso that the smooth side of the plate is facing you. Refer to Diagram 7. Secure the mounting bracket by inserting the two short screws. Tighten the screws into the recessed holes on the mounting plate using the Phillips head screwdriver. Do not over tighten the screws because too muchpressuremaycracktheplasticmountingplate.
6.Unwrap the reed switch wire. The reed switch wire has a connector on one end and the
page 10