Installing or removing the battery
Insert and click the battery into place, then close the telephone cover. Unclip the cover, then remove the battery.
Charging the battery
Connect the battery charger to your phone and mains socket respectively.
•LED light will be on when it is charging, and be off when battery is fully charged.
•Charging may take about 20 minutes to start if the battery is flat.
•Be careful not to force the plug into the socket.
•Make sure the battery is correctly inserted before connecting the charger.
•The mains socket must be near to the phone and easily accessible (avoid electric extension cables).
•When using your telephone for the first time, charge the battery fully (approximately 3 hours). You are advised to fully charge the battery ( 
).
To reduce power consumption and energy waste, when battery is fully charged, disconnect your charger from the plug; switch off
1.2Power on your phone
Hold down the 
key until the telephone powers on, type in your PIN code if necessary and then confirm with the 
key. The Home screen is displayed.
If you do not know your PIN code or if you have forgotten it, contact your network operator. Do not leave your PIN code with your telephone. Store this information in a safe place when not in use.
If Broadcast SMS are displayed, use the 
key to browse through them
or press the 
to return to the Home screen.
While the phone is searching for a network, "Searching/Emergency" will be displayed.
1.3Power off your phone
Hold down the 
key from the Home screen.
17 | 18 |