Lochinvar SSS03 operation manual IDW Controlled Using Aquastat and Zone Circulator / Valve

Page 14

Installation & Operation Manual

4Wiring

IDW Controlled Using Aquastat and Zone Circulator / Valve

1.Install Aquastat to tank. Aquastat control (TST1085) can be ordered from your local Lochinvar distributor.

2.Connect Aquastat to the zone controller for the Indirect Water Heater Zone.

3.Adjust Aquastat to the desired temperature.

Figure 4-2Wiring for Zone Control

14

Image 14

Contents Save this manual for future reference Contents Hazard definitionsWhen servicing the indirect water heater Please read before proceedingComponent Material General InformationOperating Restrictions Locating the Tank Pre-installationCharacteristic Min Max Recommended ClearancesPiping Boiler Side Piping1Piping Diagram Zoned with Circulators 2Piping Diagram Zoned with Valves 3Knight Boiler Primary / Secondary Piping Tank Piping with a Temperature Limiting Valve Domestic Side PipingDomestic Water Piping for Distant Fixtures Relief Valve Discharge Piping5Recommended Domestic Water Piping Wiring Indirect Water Heater Sensor Setup Knight BoilerIDW Controlled Using Aquastat and Zone Circulator / Valve 2Wiring for Zone ControlMaintenance Start-up and Check-outLimited Lifetime Indirect Water Heater Warranty This warranty also does not coverLimited Lifetime Indirect Water Heater Warranty Model Number Serial Number Date of InstallationPage