3.4.6 Super IO Configuration
BIOS SETUP UTILITY |
|
| |
Advanced |
|
|
|
Configure Super IO Chipset |
| Allow BIOS to Enable | |
|
| or Disable Floppy | |
Serial Port Address | [3F8 / IRQ4] | Controller. | |
|
| ||
Parallel Port Address | [378] |
|
|
Parallel Port Mode | [ECP + EPP] |
|
|
EPP Version | [1.9] |
|
|
ECP Mode DMA Channel | [DMA3] |
|
|
Parallel Port IRQ | [IRQ7] |
|
|
|
|
| Select Screen |
|
|
| Select Item |
|
| +- | Change Option |
|
| F1 | General Help |
|
| F9 | Load Defaults |
|
| F10 | Save and Exit |
|
| ESC | Exit |
v02.54 (C) Copyright | |||
Serial Port Address
Use this item to set the address for the onboard serial port or disable it. Configuration options: [Disabled], [3F8 / IRQ4], [2F8 / IRQ3], [3E8 / IRQ4], [2E8 / IRQ3].
Parallel Port Address
Use this item to set the address for the onboard parallel port or disable it. Configuration options: [Disabled], [378], and [278].
Parallel Port Mode
Use this item to set the operation mode of the parallel port. The default value is [ECP+EPP]. If this option is set to [ECP+EPP], it will show the EPP version in the following item, “EPP Version”. Configuration options: [Normal],
EPP Version
Use this item to set the EPP version. Configuration options: [1.9] and [1.7].
ECP Mode DMA Channel
Use this item to set the ECP mode DMA channel. Configuration options: [DMA0], [DMA1], and [DMA3].
Parallel Port IRQ
Use this item to set the IRQ for the parallel port. Configuration options: [IRQ5] and [IRQ7].
3 3