(see p.15, No. 24)
(see p.15, No. 25)
USB 3.0 Header | Besides four default USB 3.0 |
ports on the I/O panel, there is | |
(see p.15, No. 9) | one USB 3.0 header on this |
| motherboard. This USB 3.0 |
| header can support two USB 3.0 |
| ports. |
|
|
Infrared Module Header | This header supports an |
optional wireless transmitting | |
(see p.15, No. 28) | and receiving infrared module. |
|
|
Consumer Infrared Module Header | This header can be used to |
connect the remote | |
(see p.15 No. 26) | controller receiver. |
Front Panel Audio Header |
|
| GND | |||||||||
|
|
|
| PRESENCE# | ||||||||
|
|
|
|
|
| MIC_RET | ||||||
|
|
|
|
|
|
|
|
|
|
| OUT_RET | |
(see p.15, No. 30) | 1 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
| OUT2_L | |
|
|
|
|
|
|
|
| J_SENSE | ||||
|
|
|
|
|
|
| OUT2_R | |||||
|
|
|
|
| MIC2_R | |||||||
|
|
| MIC2_L |
This is an interface for front panel audio cable that allows convenient connection and control of audio devices.
1.High Definition Audio supports Jack Sensing, but the panel wire on the chassis must support HDA to function correctly. Please follow the instruction in our manual and chassis manual to install your system.
2.If you use AC’97 audio panel, please install it to the front panel audio header as below:
A.Connect Mic_IN (MIC) to MIC2_L.
B.Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
41