▶Restore On AC Power Loss
This item specifies whether your system will reboot after a power failure or interrupt occurs. Settings are:
[Off] | Always leaves the computer in the power off state. |
[On] | Always leaves the computer in the power on state. |
[Last State] | Restore the system to the status before power failure or interrupt |
| occurred. |
▶Wake Up Event Setup
Press <Enter> and the following
▶Wake up Event By
Setting to [BIOS] activates the following fields, and use the following fields to set the wake up events. Setting to [OS], the wake up events will be defined by OS.
▶Resume From S3 By USB Device
The item allows the activity of the USB device to wake up the system from S3 (Sus- pend to RAM) sleep state.
▶Resume From S3 By PS/2 Keyboard / Mouse
These items determine whether the system will be awakened from what power sav- ing modes when input signal of the PS/2 keyboard/ mouse is detected.
▶Resume By PCI Device (PME#)
When set to [Enabled], the feature allows your system to be awakened from the power saving modes through any event on PME (Power Management Event).
▶Resume By 
When set to [Enabled], the feature allows your system to be awakened from the power saving modes through any event on PCIE device.
▶Resume By RTC Alarm
The field is used to enable or disable the feature of booting up the system on a scheduled time/date.
▶Date/ HH:MM:SS
If Resume By RTC Alarm is set to [Enabled], the system will automatically resume (boot up) on a specific date/hour/minute/second specified in these fields (using the <+> and
[Date] | 01 | ~ 31, Every Day |
[HH:MM:SS] | 00 | ~ 23 : 00 ~ 59 : 00 ~ 59 |