BIOS Setup
read command starts.
▶tRRD
Specifies the
▶tRTP
Time interval between a read and a precharge command. ▶tFAW
This item is used to set the tFAW (four activate window delay) timing. ▶tWCL
This item is used to set the tWCL (Write CAS Latency) timing.
▶Advanced Channel
1/ 2 Timing Configuration
Press <Enter> to enter the
▶GT OverClocking
This item allows you to enable/ disable the overclocking of integrated graphics. ▶GT Ratio
This setting controls the ratio of integrated graphics frequency to enable the integrated graphics to run at different frequency combinations.
▶Adjusted GT Frequency
It shows the iGPU frequency.
▶Spread Spectrum
This function reduces the EMI (Electromagnetic Interference) generated by modulating clock generator pulses.
Important
•If you do not have any EMI problem, leave the setting at [Disabled] for optimal system stability and performance. But if you are plagued by EMI, select the value of Spread Spectrum for EMI reduction.
•The greater the Spread Spectrum value is, the greater the EMI is reduced, and the system will become less stable. For the most suitable Spread Spectrum value, please consult your local EMI regulation.
•Remember to disable Spread Spectrum if you are overclocking because even a slight jitter can introduce a temporary boost in clock speed which may just cause your overclocked processor to lock up.
▶CPU Core Voltage/ DRAM Voltage.
These items are used to adjust the voltage of CPU and Memory.
▶Current CPU Core Voltage/ Current DRAM Voltage These items show current CPU/ DRAM voltage.