MSI MS-91E2 manual Installing Memory Modules

▍Hardware Setup

Memory

These DIMM slots are intended for memory modules.

DDR3

240-pin, 1.5V

48x2=96 pin 72x2=144 pin

Installing Memory Modules

1.The memory module has only one notch on the center and will only fit in the right orientation.

2.Insert the memory module vertically into the DIMM slot. Then push it in until the golden finger on the memory module is deeply inserted in the DIMM slot. The plastic clip at each side of the DIMM slot will automatically close when the memory module is properly seated.

3.Manually check if the memory module has been locked in place by the DIMM slot clips at the sides.

Important

You can barely see the golden finger if the memory module is properly inserted in the DIMM slot.

Notch

Volt

Important

To enable successful system boot-up, always insert the memory modules into the DIMM1 first.

2-6