Teka HW80-1201B, HW80-1401, HW70-1401S, HW70-1201S, HW70-1001 manual Troubleshooting, Problem

Page 19

maintenance 19

Troubleshooting

TROUBLESHOOTING

The following circumstances do not constitute problems. Do not contact the Service Center until the problem has been confirmed.

PROBLEM

Washing machine fails to operate.

Washing machine cannot be filled with water.

Machine is draining while being filled.

Drainage failure.

Strong vibration while spinning.

Operation stops before completing wash cycle.

Operation stops for a period of time.

Excessive foam in the drum, which is spilled to the distribution drawer.

Automatic adjustment of the washing time.

Spinning fails

CAUSES

¬Poor connection to the power supply.

¬Power failure.

¬The washer door is not properly closed.

¬Machine has not been switched on.

¬The "Start/Pause" button is not pressed.

¬Water tap is not turned on.

¬Water pressure is less than 0,03 Mpa.

¬The inlet hose is kinked.

¬Water supply failure.

¬The program knob is not properly set.

¬The washer door is not properly closed.

¬The inlet hose filter is blocked.

¬The height of the drain hose is below 80 cm.

¬The drain hose is in water.

¬Drain hose is blocked.

¬Drain hose end is higher than 100 cm above the floor level.

¬The filter is blocked.

¬Not all transportation bolts have been removed.

¬Washing machine is located on an uneven surface or is not level.

¬Machine load is over 8(7)(6) kg.

¬Water or electricity failure.

¬Washing machine gives an error message.

¬Washing machine is in soaking cycle?

¬The detergent is not a low-foaming type or for manual wash.

¬Excessive use of detergent.

¬The washing program duration will be adjusted

¬Unbalance of the laundry

SOLUTIONS

_ Check connection to the power supply. _ Check the power supply.

_ Close the washer door properly.

_ Make sure the machine is switched on.

_ press the "Start/Pause" button. _ Turn on the water tap.

_ Check water pressure. _ Check the inlet hose.

_ Ensure the water supply.

_ Set the program knob properly. _ Close the washer door properly. _ Unblock the inlet hose filter.

_ Install drain hose within 80-100 cm of height. _ Make sure the drain hose is not in water.

_ Unblock the drain hose.

_ Make sure the drain hose end is lower than 100 cm above floor level.

_ Unblock the filter.

_ Remove all transportation bolts.

_ Make sure the washing machine is on an even surface and levelled.

_ Reduce amount of laundry in the drum. _ Check the power supply or water supply.

_ Check display codes.

_ Press the rinse hood button or the Start/pause button again to cancel it.

_ Check if your detergent is appropriate.

_ Reduce amount of detergent in the distribution drawer.

_ This is normal and doesn't affect the functionality.

_ Add clothes or run a spinning program again.

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Automatic Drum Washing Machine 03 09 10 15 16 Table of contentsBefore use AccessoriesThanks for purchasing a Teka product Control panel DescriptionDetergent distribution drawer During Daily use of the appliance Safety instructionsBefore switching the appliance on for the first time Do notRemove the back cover InstallationAdjusting the washing machine Dismantle the Transportation boltsInlet Hose Connecting to the power supplyHose-sets should not be reused Drain hose Intense button Extra rinse button Control PanelRinse hold ¬Delay Button¬Display Intense buttonProgram selection Using the ApplianceProgram Modes MAX Consumption and technical dataTechnical Data Consumption TableWater connection Power supplyTurn on the tap. The water must be clean and clear Washing methodsAdding detergent Loading the machine¬ Do not overload the washing machine Selecting detergentAfter washing Setting washing temperatureSetting spin speed WashingLoad Reference Care chartIron at 100 C Dont ironCleaning the machine MaintenanceCleaning & care Cleaning the detergent drawerLong periods of disuse Water inlet Valve and inlet Valve filterMoving the machine Tighten the bolts with a spanner Replace the back coverCodes SolutionsDisplay codes Display Codes and Special FunctionsTroubleshooting TroubleshootingProblem Water Connection Green and Yellow Earth Blue Neutral Brown Live

HW70-1201S, HW70-1201, HW80-1201B, HW70-1001, HW80-1201 specifications

The Teka range of washing machines, including models HW80-1401, HW70-1401S, HW80-1201, HW70-1001, and HW80-1201B, represents a blend of advanced technology and user-friendly operation, making them ideal for modern households. These machines are renowned for their efficiency, performance, and eco-friendly features, catering to diverse washing needs.

The HW80-1401 model is particularly impressive with an 8 kg capacity and 1400 RPM spin speed, allowing users to handle larger loads with quick drying times. This model is equipped with various wash programs tailored for different fabrics and stains, ensuring optimal cleaning without damaging garments. The inclusion of an inverter motor not only enhances efficiency but also minimizes noise levels during operation.

Similarly, the HW70-1401S offers a 7 kg capacity and the same high spin speed, making it suitable for daily washing requirements. This model features a smart digital display that simplifies program selection and monitoring, allowing users to track the washing cycle effortlessly. Energy efficiency is a standout characteristic of this machine, often rated A+++ for its low power consumption.

The HW80-1201 model combines an 8 kg load capacity with 1200 RPM. Its focus on fabric care is highlighted through specialized cycles such as delicate, wool, and anti-allergy cleaning processes, appealing to users with sensitive skin or specific fabric care needs.

For those with slightly lower capacity needs, the HW70-1001 offers a 7 kg load with a 1000 RPM spin speed. This model balances price and performance effectively, catering to smaller households or those with limited space.

Lastly, the HW80-1201B model boasts an 8 kg capacity alongside a sleek black design that adds a modern touch to any laundry room. It features multiple wash programs and a quick wash function, addressing the fast-paced lifestyle of today’s consumers.

All models benefit from Teka’s dedication to sustainability, with features like eco-mode, which uses less water and energy per cycle, contributing to lower environmental impact. Overall, the Teka HW series is designed to meet various consumer needs, ensuring effective cleaning while promoting energy-efficient use.
Top Page Image Contents