Teka HW80-1201, HW80-1401 manual Green and Yellow Earth Blue Neutral Brown Live, Water Connection

Page 20

20 Important Safety Information

Do not use a multiple socket extension cord. A separate earthed socket is required which shall be accessible at all times.

If the mains cord becomes damaged, it must be replaced by the manufacturer, its service agent or similarly qualified person with a lead of the same type and rating to avoid a hazard.

Never remove the plug from the socket by pulling on the cord, always grasp the plug.

The door may get hot during use, do not touch it and keep children away whilst the machine is operating. Never open the detergent drawer while the machine is running.Hot water and detergent might be ejected. When installing the product, make sure the mains cord is not trapped or twisted.

WARNINGS:

THIS APPLIANCE IS INTENDED FOR DOMESTIC USE ONLY, COMMERCIAL OR ANY OTHER USE MAY INVALIDATE THE WARRANTY AND MIGHT BE DANGEROUS.

Never touch or operate the machine with wet hands or when bare footed.

Do not put the machine on a carpet that can block the ventilation slots on the bottom of the unit. Do not install this machine outdoors or in a damp place or expose it to rain.

Do not install this product near a heat source or in direct sunlight. Do not place any object on the machine when it is operating. This appliance must be earthed.

If you are disposing of an old appliance,disable the door lock to avoid entrapment of children when playing and cut off the mains cord close to the machine.

The appliance must be connected to a 220-240 volts 50 cycle AC supply by means of a three pin socket, suitably earthed and should be protected by a 13 amp fuse in the plug.

The appliance is supplied with a standard 13 amp 3-pin plug fitted with a 13-amp fuse. Should the fuse require replacement, it must be replaced with a fuse rated at 13 amps and approved to BS1362.

If the mains plug is unsuitable for the socket outlet in your home or is removed for any other reason,then the cut off plug should be disposed of safely, do not insert the cut off plug into a mains outlet to prevent the hazard of electric shock. Remove the fuse before disposal.

There is a danger of electric shock if the cut off plug is inserted into any 13-amp socket outlet. How to wire a 13 amp plug. (UK Only)

The wires in the mains lead on this appliance are coloured in accordance with the following code:

Green and Yellow - Earth Blue – Neutral Brown – Live

As the colours may not correspond with the markings identifying the terminals in your plug proceed as follows. The green and yellow wire must be connected to the terminal in the plug which is marked with the

letter E or with the earth symbol

or coloured green and yellow.

The blue wire must be connected to the terminal marked N. The brown wire must be connected to the terminal marked L.

You must make sure the lead is firmly secured under the cord clamp.

WATER CONNECTION

The product should be connected to the water main using new hose sets, old hose sets should not be re used. The water pressure must not be less than 0.03MPa.

Connect to the water main using a standard 3/4 inch threaded tap outlet.

Page 19 Page 20
Image 20
Page 19 Page 20
Contents Automatic Drum Washing Machine Table of contents 03 09 10 15 16Thanks for purchasing a Teka product AccessoriesBefore use Detergent distribution drawer DescriptionControl panel Safety instructions Before switching the appliance on for the first timeDo not During Daily use of the applianceInstallation Adjusting the washing machineDismantle the Transportation bolts Remove the back coverHose-sets should not be reused Drain hose Connecting to the power supplyInlet Hose Control Panel Intense button Extra rinse button¬Delay Button ¬DisplayIntense button Rinse holdProgram Modes Using the ApplianceProgram selection Consumption and technical data Technical DataConsumption Table MAXPower supply Turn on the tap. The water must be clean and clearWashing methods Water connectionLoading the machine ¬ Do not overload the washing machineSelecting detergent Adding detergentSetting washing temperature Setting spin speedWashing After washingCare chart Iron at 100 CDont iron Load ReferenceMaintenance Cleaning & careCleaning the detergent drawer Cleaning the machineWater inlet Valve and inlet Valve filter Moving the machineTighten the bolts with a spanner Replace the back cover Long periods of disuseSolutions Display codesDisplay Codes and Special Functions CodesProblem TroubleshootingTroubleshooting Green and Yellow Earth Blue Neutral Brown Live Water Connection

HW70-1201S, HW70-1201, HW80-1201B, HW70-1001, HW80-1201 specifications

The Teka range of washing machines, including models HW80-1401, HW70-1401S, HW80-1201, HW70-1001, and HW80-1201B, represents a blend of advanced technology and user-friendly operation, making them ideal for modern households. These machines are renowned for their efficiency, performance, and eco-friendly features, catering to diverse washing needs.

The HW80-1401 model is particularly impressive with an 8 kg capacity and 1400 RPM spin speed, allowing users to handle larger loads with quick drying times. This model is equipped with various wash programs tailored for different fabrics and stains, ensuring optimal cleaning without damaging garments. The inclusion of an inverter motor not only enhances efficiency but also minimizes noise levels during operation.

Similarly, the HW70-1401S offers a 7 kg capacity and the same high spin speed, making it suitable for daily washing requirements. This model features a smart digital display that simplifies program selection and monitoring, allowing users to track the washing cycle effortlessly. Energy efficiency is a standout characteristic of this machine, often rated A+++ for its low power consumption.

The HW80-1201 model combines an 8 kg load capacity with 1200 RPM. Its focus on fabric care is highlighted through specialized cycles such as delicate, wool, and anti-allergy cleaning processes, appealing to users with sensitive skin or specific fabric care needs.

For those with slightly lower capacity needs, the HW70-1001 offers a 7 kg load with a 1000 RPM spin speed. This model balances price and performance effectively, catering to smaller households or those with limited space.

Lastly, the HW80-1201B model boasts an 8 kg capacity alongside a sleek black design that adds a modern touch to any laundry room. It features multiple wash programs and a quick wash function, addressing the fast-paced lifestyle of today’s consumers.

All models benefit from Teka’s dedication to sustainability, with features like eco-mode, which uses less water and energy per cycle, contributing to lower environmental impact. Overall, the Teka HW series is designed to meet various consumer needs, ensuring effective cleaning while promoting energy-efficient use.
Top Page Image Contents