Lennox International Inc 81M26, 81M28 Energy Efficient Recovery, Deadband Setpoint, Humiditrol

Page 23

110-1052F 5/12/05 11:59 AM Page 23

INSTALLER settings (continued)

ENERGY EFFICIENT

RECOVERY

DISABLE

ENABLE

USER MENU

SELECT

DEADBAND SETPOINT

3˚F

ENERGY EFFICIENT RECOVERY

When turned on, the thermostat will look up to two hours before the next event and anticipate when to turn on to reach the desired temperature.

NOTE: This will not allow the second stage to turn on until 20 minutes before the event.

DEADBAND SETPOINT

Deadband is used only when the AUTO CHANGEOVER feature is enabled. The deadband is the temperature difference between the heating and cooling setpoints. This is adjustable from 3-8°F (2.0-4°C).

USER MENU

SELECT

HUMIDITROL

DISABLE

ENABLE

INSTALL MENU

SELECT

ENTER SECURITY CODE

FOR INSTALLER

SETTINGS

0 0 0 0

HUMIDITROL

If the HUMIDITROL accessory is present in the HVAC equipment, this feature should be enabled. Otherwise, it should be disabled.

SECURITY CODE

Enter a code to prevent changes to the INSTALLER settings.

USER MENU

SELECT

Image 23

Contents 81M26 81M27 81M28 Do not USE with Commercial Equipment Important Safety InformationTable of Contents Menu How do I change the time of day and day of the week?How do I turn on the heating or cooling cycles? How does Intermittent FAN work? How do I cycle the fan?SET Temperature AT How do I temporarily change the temperature?70 ˚ Can I set a temporary adjustment for longer than 3 hours?70 ˚ How do I return to the Program Mode after being in HOLD?How do I set the Vacation Mode? 70˚Day to be set the same. MON-FRI allows for weekday How do I program my thermostat?SET Cool Monday Program How do I copy one day’s program to another day?How do I know what program is right for me? What is an event?How do I set the Dehumidify Levels? What is the difference between Basic and Precision modes?Can I change the Humidifier Maintenance Service Intervals? What happens if the mode is set to OFF?What is the Dew Point Adjustment Function? Or C What are the User settings?Number of Events PER DAY Clock SettingsSetpoint Temperature Differential Settings More Detailed Information on the User SettingsSecurity Code When would I need to change the User settings?Security Settings System Setup What are the Installer settings?Balance Points Installer settingsAuxiliary Heat Residual CoolHumiditrol Energy Efficient RecoveryDeadband Setpoint Contact Information When would I need to change the Installer settings?Service Monitor Menu Temperature OffsetWhat do the lights below the display mean? How does Energy Efficient Recovery EER work?Where should I install a remote outdoor sensor? How does my remote outdoor sensor work?Who do I contact for more information? What should I do if my power goes out?How do I know if the heating or cooling is on? My energy bills are too high. Is there anything I can do? 504, 684M