61401134/329 ingles 18/7/03 16:55 Página 12
3Remove the four lockpins from the ends (B).
4Partially insert the oven in its position, taking care not to snag the telescopic universal joints which are hanging from the underside of the hob, and leave sufficient space to be able to connect the other ends of the joints to the rods at the rear part of the control panel, before finally connecting the lockpins.
5For the electrical connection between the two appliances, connect the hob connector to the oven connector (mod. CG.1 3G 1P and CGC 4G AI AL).
Rear view of the Control Panel:
1
3 2
Drawing 17
1Flexible Power Cable.
2Connector.
3Power Unit Protective Casing.
6Position the oven in its definitive location, ensuring that the telescopic universal joints are well connected to the rods and that the telescopic tubes are introduced well aligned with each other in order to favour their movement.
7Position the control panel on the oven’s fascia.
8To operate, the controls must be pressed in and then turned in order to release the safety device.
12
If the telescopic universal joints are too short, extensions can be used. These are inserted at pressure and fastened with the corresponding cover.
To make the oven’s electrical connection, con- sult the oven’s instruction manual.
Hob model CGC 4G AI AL
This hob should be fitted onto the oven by following the same method, except for item 7, where the procedure shall be as follows:
Fix the hob knob covers on the oven according to the oven instructions manual. Fix the knob covers included with the hob and remove tho-
se for the oven.
This hob comes complete with knob covers for all TEKA ovens except for models
Gas Connection
The hob’s gas connection to the mains supply must be made in accordance with the applica- ble installation regulations and by qualified technical personnel (an authorized installer). The gas connection for these hobs must be by means of rigid piping, given that this is an immobilized appliance, in the case of hobs destined for the EC. The hob is prepared with a 1/2" diameter screw connection according to ISO
For the markets with 1/2" ISO
The room must be provided with adequate ven- tilation, in accordance with the applicable regulations.