Eng

Cleaning and maintenance

During cleaning and maintenance work, make sure the safety instructions set out on page 10 are complied with.

Cleaning the hood body

•If your kitchen hood is made from stainless steel, use proprietary cleaners mentioned in the product instructions.

•Never use metallic scourers, nor abrasive or corrosive products.

•Dry the kitchen hood using a cloth that does not produce fibres.

Cleaning the metal filters

To remove the filters from their fittings, press lightly on the locks and then pull them off.

The metal filters can be cleaned by soaking them in hot water with neutral detergent until the fat dissolves and then rinsing them under the tap or using special anti-grease products. They can also be washed in a dishwasher. In this case, it is advisable to stack them vertically to avoid food residues to stick to them.

Cleaning in a dishwasher may damage the metallic surface (blackening it), although this will not affect its fat retention capacity.

Once clean, leave them to dry off and then fit them onto the kitchen hood.

Changing light bulbs

Proceed as follows:

•Unscrew the lamp cap trimming cover.

•Change the broken/ burnt out lamp. Maximum lamp power is 20 W (G-4).

•Screw in the lamp cap trimming cover.

_________________________________________________________

Problem solving

Proceed with the following checks before calling the Technical Service:

Sizes and specifications

See page 30.

TEKA INDUSTRIAL S.A. reserves the right to make changes and corrections to its products as it deems necessary, without altering their basic characteristics.