Manual ND.qxd 12/01/2005 17:10 Page 16
ENG
Cleaning and maintenance
During cleaning and maintenance work, make sure the safety instructions set out on page 14 are complied with.
Cleaning the hood body
•If your kitchen hood is made from stainless steel, use proprietary cleaners mentioned in the product instructions.
•Never use metallic scourers, nor abrasive or corrosive products.
•Dry the kitchen hood using a cloth that does not produce fibres.
Cleaning the metal filters
Extract the filters from their housings using the handles specially designed for this purpose.
The metal filters can be cleaned by soaking
them in hot water with neutral detergent until the fat dissolves and then rinsing them under the tap or using special
Cleaning in a dishwasher with aggressive detergents or polish may damage the metallic surface (blackening it), although this will not affect its fat retention capacity.
Once clean, leave them to dry off and then fit them onto the kitchen hood.
Changing light bulbs
Proceed as follows:
•Unscrew the lamp cap trimming cover.
•Change the broken/burnt out lamp. Maximum lamp power is 20 W
•Screw in the lamp cap trimming cover.
_________________________________________________________
Problem solving
Proceed with the following checks before calling Technical Services:
Problem | Possible cause | Solution |
|
|
|
The extractor fan does not work. | The mains cable is not connected to the | Connect mains cable to the network. |
| network. |
|
| There is no current in the network. | Provide current to the network. |
|
|
|
The kitchen hood does not extract | Filters are saturated with fat. | Change or clean the active charcoal and/or metal |
sufficiently or vibrates. |
| filters, as the case may be. |
Obstruction in the air exit conduct.
Remove the obstruction.
The lamps do not light up.
The lamps are blown.
Change the lamps.
The lamps are slack.
Tighten the lamps.
16