Tefal BL142140 manual 60 C 140F, For more than 60 seconds

SETTING UP

Blender :

With the “click” button (D2) of the blade unit (D1) in front of you, place the base of the bowl	EN
(D4) under the rib (D3) (fig. 2a) and then bring back the blade unit (D1) onto the bowl (fig.
2b), lock by pressing the “click” button (D2) and then release it. Make sure that the bowl (D4)
and the blade unit (D1) are well connected (fig. 2c).
Add the ingredients in the bowl without exceeding the maximum level indicated.
0.6 l for the thick preparations
0.5 l for the liquid preparations
Do not put liquid or any ingredients in the blender bowl where the temperature exceeds
60° C (140°F).
Put the lid (D6) on the bowl (D4), lock the cap (D7) in its housing situated on the lid.
Fit the assembled bowl (D) on the motor unit (A), with click button (D2) of the blade unit
aligned with the notch situated on the front of the motor unit (A) ( fig. 3). The bowl (D) must
be pushed down far enough on the motor unit (A) or the appliance will not work (fig. 4).
Accessories:
With the “click” button (E2) or (F2) of the blade unit (E1) or (F1) in front of you, place the
base of the bowl (E4) or (F4) under the rib (E3) or (F3) (fig. 5a) and then bring back the
blade unit (E1) or (F1) to the bowl (fig. 5b), lock by pressing the “click” button (E2) or (F2)
and then release it. . Make sure that the bowl (E4) or (F4) and the blade unit (E1) or (F1) are
well connected (fig 5c).
Check whether there is no error in the assembly of the accessories (E) and (F): the colour of the click
button (E2 or F2) must correspond to the colour of the line on the base of the bowl (E4 or F4).
Place the assembled accessory (E) or (F) on the motor unit (A). The click button (E2) or (F2)
must be in front of you. Push it until the marking is no longer visible, otherwise the appliance
will not work (fig. 6).
USING YOUR APPLIANCE
Blender:
Plug in the appliance and press on the button 1 (C) or 2 (B), depending on the required speed,
pressing several times for pulse operation or holding down for continuous operation. Do not run
for more than 60 seconds.
To stop the appliance, release the pressure on the button (B) or (C) unplug the appliance.
Remove the bowl (D) from the motor unit (A).
Accessories:
Plug in the appliance. Put the ingredients into the bowl (E4) or (F4).
Keep your hand supporting the bowl (E4) or (F4) and during operation press on button (B) or
(C) several times in short pulses (fig 7).
To stop the appliance, release button (B) or (C). Unplug the appliance.
Remove the accessory (E) or (F) from the motor unit (A), turn over the accessory on the work
surface and release the blade unit (E1) or (F1) by pressing on the “click” button (E2) or (F2).
You can then take out your preparation.
The lid (G) can be fitted on the bowl (E4) or (F4) to avoid preparations from drying out and also
allows them to be kept in the refrigerator for later use.

6