NuTone LA-107 Wiring Connections Replacement Installation, Attaching Chime Cover, Wiring Hints

Page 2

WIRING CONNECTIONS

 

REPLACEMENT INSTALLATION

1.Use wire nuts to make connections. Insulate all connections with electrical tape.

2.INSTALLATION USING TRANSFORMER.

Refer to Figure 2. Connect pushbutton and transformer wires to terminal screws marked Front, Transformer, and Rear.

3.INSTALLATION USING BATTERIES.

Refer to Figure 3. Connect pushbutton wires to terminal screws marked Front, Common, and Rear.

WIRING HINTS

1. Carefully fasten wiring to wall studs and ceiling joists. Avoid short circuits caused by staples or clops cutting through the wiring's insulation.

2.Loop wire around terminal screws.

3.When connecting more than one wire

to a single terminal screws, twist the wires together before looping them around the terminal screw.

4.Make sure all terminal screws are tightened securely.

BATTERY INSTALLATION

1.Install four (4) “D” size batteries as shown in Figure 4.

2.For longer life, alkaline batteries are recommended.

ATTACHING CHIME COVER

1.Place cover over base.

2.Refer to Figure 5. Secure cover by placing mounting tab into slot at back of base.

1.Turn off house power until installation is complete.

2.Remove cover from existing chime and disconnect wires from terminal screws. Label all wires (Front, Transformer, Rear) as you remove them. NOTE: Any additional wires (for example: common or side) should be individually capped with wire nuts or sealed with electrical tape and pushed back into the wall cavity. These wires are not needed.

3.Remove existing chime base from wall.

4.Pull wires through holes in new chime base.

5.Use provided screws to mount base to wall.

6.Connect wires to terminal screws marked Front, Transformer, and Rear on the chime base.

7.Place chime cover securely over the base.

8.Restore house power to chime.

CHIME

MOUNTING TAB

COVER

MOUNTING SLOT

CHIME

BASE

FIGURE 5

One Year Limited Warranty

WARRANTY OWNER: NuTone warrants to the original consumer purchaser of its products that such products will be free from defects in materials or workmanship for a period of one (1) year from the date of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED

WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

During this one year period, NuTone will, at its option, repair or replace, without charge, any product or part which is found to be defective under normal use and service.

THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS OR TUBES, FILTERS, DUCT, ROOF CAPS, WALL CAPS AND OTHER ACCESSORIES FOR DUCTING. This warranty does not cover (a) normal maintenance and service or (b) any products or parts which have been subject to misuse, negligence, accident, improper maintenance or repair (other than by NuTone), faulty installation or installation contrary to recommended installation instructions.

The duration of any implied warranty is limited to the one year period as specified for the express warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above limitation may not apply to you.

NUTONE’S OBLIGATION TO REPAIR OR REPLACE, AT NUTONE’S OPTION, SHALL BE THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY. NUTONE SHALL NOT BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. This warranty supersedes all prior warranties.

WARRANTY SERVICE: To qualify for warranty service, you must (a) notify NuTone at the address stated below or telephone 1/800-543-8687, (b) give the model number and part identification and (c) describe the nature of any defect in the product or part. At the time of requesting warranty service, you must present evidence of the original purchase date.

Date of Installation

Builder or Installer

 

 

Model No. and Product Description

 

 

IF YOU NEED ASSISTANCE OR SERVICE:

 

For the location of your nearest NuTone Independent Authorized Service Center:

 

Residents of the contiguous United States Dial Free 1-800-543-8687

 

Please be prepared to provide:

 

Product model number • Date and Proof of purchase • The nature of the difficulty

Residents of Alaska or Hawaii should write to: NuTone Inc. Attn: Department of National Field Service, 4820 Red Bank Road, Cincinnati Ohio 45227-1599.

Residents of Canada should write to: Broan-NuTone Canada, 1140 Tristar Drive, Mississauga, Ontario, Canada L5T 1H9.

Rev. 03/2001

Product specifications subject to change without notice.

4820 Red Bank Road, Cincinnati, Ohio 45227

Printed in U.S.A., Rev. 3/01 Part No. 83527

Image 2
Contents Installing Transformer NEW InstallationInstalling the Wiring LocationBattery Installation Wiring Connections Replacement InstallationWiring Hints Attaching Chime Cover

LA-107 specifications

The NuTone LA-107 is a versatile and efficient ventilation fan designed for residential bathrooms and other humid areas. With a focus on performance and quiet operation, this model stands out for its innovative features and user-friendly design. One of the main attractions of the LA-107 is its powerful airflow capacity. The fan is capable of moving up to 70 cubic feet of air per minute (CFM), ensuring that moisture is effectively removed from the room, helping to prevent mold and mildew growth.

In addition to its performance, the LA-107 is engineered for quiet operation. Equipped with a specially designed motor, this ventilation fan operates at a sound level of only 2.5 sones, making it one of the quieter options available on the market. This low noise output ensures that the fan can function without disrupting the tranquility of the household environment, making it ideal for use in bathrooms, laundry rooms, or other areas where peace and quiet is desired.

The NuTone LA-107 is designed with ease of installation in mind. Its lightweight construction and compact size allow for a straightforward ceiling mount process, whether in new construction or during renovations. The fan comes with a simple installation guide, making it accessible for both DIY enthusiasts and professional installers alike.

Another notable feature is the integrated light fixture that provides additional illumination in the bathroom. This dual-functionality means that users can benefit from not just ventilation but also improved visibility in a sleek and cohesive unit. The LA-107 is compatible with incandescent bulbs, allowing homeowners to choose the brightness level that suits their needs.

Durability is a key characteristic of NuTone products, and the LA-107 is no exception. Constructed from high-quality materials, it promises longevity and reliability, with a sleek white grille that complements various bathroom decors. Additionally, it comes with a limited warranty, which offers peace of mind for users.

Overall, the NuTone LA-107 combines performance, quiet operation, easy installation, dual functionality, and durability, making it an excellent choice for any homeowner looking to enhance their bathroom's ventilation system. This fan not only improves air quality but also contributes to a more comfortable and inviting living space.