N | Installation |
|
|
|
E |
|
|
|
|
G |
|
|
|
|
L |
|
|
|
|
I | Preparation | Supplied Hardware |
| |
S |
| |||
H | No. | Item | Diagram Q’ty | |
|
| |||
27 ¡Before installation, check the radio operation with |
| Mounting Collar | 1 | |
| antenna and speakers. | q | ||
| ¡Disconnect the cable from the negative |
|
|
|
| terminal (see caution below). | w Mounting Bolt (5 mmø) | 1 | |
| ¡Unit should be installed in a horizontal position with the | |||
|
|
|
| |
| front end up at a convenient angle, but not more than |
|
|
|
| 30°. | e | Power Connector | 1 |
|
| r Removable Face Plate Case | 1 | |
|
| t | Trim Plate | 1 |
| 30° or less |
|
|
|
|
| y | ISO Antenna Adapter | 1 |
u
Lock Cancel Plate
2
Caution: Do not disconnect the battery terminals of a car with trip or navigational computer since all user settings stored in memory will be lost. Instead take extra care with installing the unit to prevent shorts.
Dashboard Installation
Installation Opening
The unit can be installed in any dashboard having an
opening as shown at right. 
182 mm 
The dashboard should be
4.5mm - 6 mm thick in order to be able to support the unit.
Installation Precautions
This product should be installed by a professional installer, if possible.
In case of difficulty, please consult your nearest authorized Panasonic Service Center.
1.This system is to be used only in a
2.Follow the electrical connections carefully (a Page 34). Failure to do so may result in damage to the unit.
3.Connect the power lead (red) after all other connections are made.
4.Be sure to connect the battery lead (yellow) to the positive terminal (+) of the battery or fuse block (BAT) terminal.
5.Insulate all exposed wires to prevent short circuiting.
6.Secure all loose wires after installing the unit.
7.Please carefully read the operating and installation instructions of the respective equipment before connecting it to this unit.
Method for Fixing the Rear of the Unit
(a) Using the Rear Support Strap (Option) | |
| Fire Wall of Car |
Tapping Screw (Option) | 3 mmø |
| |
| Hex. Nut (Option) |
| Rear Support Strap (Option) |
| w Mounting Bolt |
| q Mounting Collar |
(b) Using the Rubber Cushion (Option)
Rear Support Bracket (Provided on the car)
Rubber Cushion (Option)
w Mounting Bolt
q Mounting Collar