Multiquip QP40TH Enclosed area structure that, Read safety instructions at Beginning of manual

Page 15

QP40TH — PRE-INSPECTION (ENGINE)

CAUTION

3.

Insertandremovethedipstickwithoutscrewingitintothefiller

NEVER operate the pump

 

neck. Check the oil level shown on the dipstick.

 

 

in a confined area or

4.

If the oil level is low (Figure 5), fill to the edge of the oil filler

enclosed area structure that

 

hole with the recommended oil type (Table 3).Maximum oil

does not provide ample free

 

capacity is 1.16 quarts (1.1 liters)

flow of air.

 

 

ALWAYS wear approved eye and hearing protection before operating the pump.

Before Starting

 

Figure 5. Engine Oil Dipstick (Oil Level)

1.

Read safety instructions at the

 

 

 

 

 

 

 

beginning of manual.

 

 

 

 

 

 

 

 

Table 3. Oil Type

 

2.

Clean the pump, removing dirt and

 

 

 

 

 

 

 

 

 

 

 

 

 

 

dust, particularly the engine

 

Season

Temperature

Oil Type

 

cooling air inlet, carburetor and air

 

 

 

 

 

 

 

Summer

25°C or Higher

SAE 10W-30

 

cleaner.

 

 

 

 

 

 

 

3.

Check the air filter for dirt and dust. If air filter is dirty, replace

Spring/Fall

25°C~10°C

SAE 10W-30/20

 

air filter with a new one as required.

 

 

 

 

 

 

 

Winter

0°C or Lower

SAE 10W-10

4.

Check carburetor for external dirt and dust. Clean with dry

 

 

 

 

 

 

 

 

 

 

 

 

compressed air.

 

 

 

 

 

5.

Check fastening nuts and bolts for tightness.

 

 

 

 

 

 

Explosive Fuel

 

 

 

 

 

 

 

Engine Oil Check

DANGER

 

 

 

1.To check the engine oil level, place the pump on secure level ground with the engine stopped.

2.Remove the filler dipstick from the engine oil filler hole (Figure 4) and wipe clean.

Motor fuels are highly flammable and can be dangerous if mishandled. DO NOT smoke while refueling. DO NOT attempt to refuel the pump if the engine is hot! or running.

Fuel Check

1.Remove the gasoline cap located on top of fuel tank.

2.Visually inspect to see if the fuel level is low. If fuel is low, replenish with unleaded fuel.

3.When refueling, be sure to use a strainer for filtration. DO NOT top-off fuel. Wipe up any spilled fuel immediately!

Figure 4. Engine Oil Dipstick (Removal)

QP40TH — PARTS & OPERATION MANUAL — REV. #1 (10/01/02) — PAGE 15

Image 15
Contents GAS Powered Trash Pump Model QP40TH Honda Page Heres HOW to GET Help Table of Contents UPS Third Day Service at one-half of actual freight cost Parts Ordering ProceduresSeriously injured if you do not follow directions QP40TH Safety Message Alert SymbolsInstructions Always wear approved respiratory protectionRules for Safe Operation General SafetyRules for Safe Operation Suction & Discharge Size Specifications PumpSpecifications Engine QP40TH General Information Port Attempting to remove clean-out coverWater Re-prime laterQP40TH Basic Engine Enclosed area structure that Read safety instructions at Beginning of manualClean the pump, removing dirt Dust, particularly the engine CleanerRead safety instructions at the beginning of manual QP40TH PRE-SETUP PumpPlace the engine fuel valve lever to the on position Place the engine ON/OFF switch in the on positionPlace the fuel shut-off lever in the OFF position QP40TH Initial START-UP EnginePage Pump Vacuum Test QP40TH Maintenance PumpQP40TH Maintenance Pump Engine Maintenance Schedule QP40TH Maintenance EngineQP40TH Maintenance Engine Pump Storage QP40TH Preparation for Long -TERM StoragePage QP40TH Troubleshooting Engine QP40TH Troubleshooting ENGINE/PUMP Explanation of Code in Remarks Column To 5 Units QP40TH Suggested Spare PartsPump Assy QP40TH Pump AssyDelivery Cover NPT4 ENGINE, Honda GX340K1QA2Casing Casing CoverQP40TH Pump Assy Spring Washer M10 NUT DELIVERY/SUCTION Cover M12Pump M10 Spring Washer M12AIR Cleaner Assy Honda GX340K1QA2 AIR Cleaner AssyCOLLAR, AIR Cleaner ELEMENT, AIR CleanerCOVER, AIR Cleaner GROMMET, AIR CleanerCamshaft Assy Honda GX340K1QA2 Camshaft AssyLIFTER, Valve SPRING, Weight ReturnROD, Push ARM, Valve RockerPiston Assy Honda GX340K1QA2 Piston AssyRing SET, Ppiston BOLT, Connecting RODRing SET, PISTON- Standard Ring SET, PISTON- OSCrankcase Cover Assy Honda GX340K1QA2 Crankcase Cover AssyGASKET, Case Cover WEIGHT, GovernorHOLDER, Governor Weight PIN, Governor WeightCrankshaft Assy Honda GX340K1QA2 Crankshaft AssyWEIGHT, Balancer Cylinder Barrel Assy Honda GX340K1QA2 Cylinder Barrel AssyBOLT, Drain Plug Includes Items WUSE from Engine SHAFT, Governor ARMCylinder Head Assy Honda GX340K1QA2 Cylinder Head AssyTUBE, Breather CLIP, Valve GuideGASKET, Cylinder Head COVER, HeadFAN Cover Assy Honda GX340K1QA2 FAN Cover AssyShroud CLIP, Wire HarnessCLIP, Tube COVER, FAN *R8* Bright REDFlywheel Assy Honda GX340K1QA2 Flywheel AssyFlywheel FAN, CoolingFuel Tank Assy Honda GX340K1QA2 Fueltank AssyGASKET, Fuel Filler CAP RUBBER, Supporter 107MMJOINT, Fuel Tank Tank Fuel *T34* Simpson BlueIgnition Coil Assy Honda GX340K1QA2 Ignition Coil AssyCoil ASSEMBLY, Ignition GROMMET, WireWIRE, Stop Switch 430MM Carburetor Assy Honda GX340K1QA2 Carburetor AssyIncludes Items W/% Gasket SETValve SET, Float Float SETHonda GX340K1QA2 Carburetor Assy 25 + 9430520122 Muffler Assy Honda GX340K1QA2 Muffler AssyPIPE, EX MufflerPROTECTOR, Muffler PROTECTOR, EX. PipeRecoil Starter Assy Honda GX340K1QA2 Recoil Starter AssySPRING, Starter Return PULLEY, Recoil StarterRATCHET, Starter SPRING, FrictionHonda GX340K1QA2 Control Assy Honda GX340K1QA2 Control Assy Labels Assy Honda GX340K1QA2 Labels AssyMARK, OIL Alert E EmblemLABEL, Caution MARK, Choke ExternalTerms and Conditions of Sale Parts Page Multiquip INC

QP40TH specifications

The Multiquip QP40TH is a robust and reliable portable generator that stands out in the industry for its powerful performance and innovative features. Designed to cater to various applications, including construction sites, outdoor events, and emergency backup power, this generator delivers an impressive balance of power and portability.

One of the key features of the QP40TH is its 40 kW output capacity, which makes it suitable for a range of applications where high power is necessary. This generator is equipped with a three-phase generator system that ensures efficient energy distribution, enabling multiple tools and equipment to run simultaneously. With a fuel-efficient operation, the QP40TH keeps operational costs down while providing consistent power delivery.

The QP40TH utilizes a high-performance diesel engine that boasts reliability and durability, making it ideal for heavy-duty use. Its industrial-grade engine is designed to withstand the rigors of job sites, ensuring long-lasting performance under challenging conditions. Additionally, the generator features a robust frame and protective enclosure, allowing it to endure harsh environments while keeping internal components secure.

In terms of technology, the Multiquip QP40TH is equipped with advanced digital control systems that enhance user experience. The intuitive control panel provides easy access to essential information such as voltage output, frequency, and hour meter. This ease of monitoring ensures that users can manage their power needs effectively without complications.

Furthermore, the generator is designed with improved noise reduction technologies, enabling quieter operation compared to traditional models. This feature is particularly beneficial for events or locations where noise regulations must be adhered to. The QP40TH also includes a fuel tank that ensures extended run times, minimizing downtime for refueling and keeping projects on schedule.

Safety is a priority with the QP40TH, which is equipped with automatic shut-off features that protect the generator from overloads and low oil levels. These safety mechanisms provide peace of mind for users, safeguarding both the generator and connected equipment.

With its combination of power, efficiency, and reliability, the Multiquip QP40TH is a versatile generator that meets the demands of various applications. Its robust features and state-of-the-art technology make it a go-to choice for professionals in construction, events, and emergency services, ensuring that power needs are met with confidence.